Can you inject oil based steroids with a slin pin?

[gstacker]

I've done it but a lil slow for me, I hit the bi's and burry the pin... Depends alot on what ur running some gears jus to thick an would take to long... A 27g 5/8 is perfect for me for tri's and delts

 

[hormoneman]

I've done it but a lil slow for me, I hit the bi's and burry the pin... Depends alot on what ur running some gears jus to thick an would take to long... A 27g 5/8 is perfect for me for tri's and delts

That's good to hear - would 27 gauge 5/8" work with Tren and Primo??

 

[HAYEZ]

No need to heat anything.....

Draw the oil with a 3ml syringe

remove plunger from slin pin

fill the insulin needle up with oil from 3ml syriunge

replace plunger and inject

do not draw with insulin pin that will dull it and take forever

 

[forged71]

Okay lets just run with a rusty pin too. This thread is getting absurd....
Peace, Forged

 

[gstacker]

That's good to hear - would 27 gauge 5/8" work with Tren and Primo??

Yes

 

[HAYEZ]

Okay lets just run with a rusty pin too. This thread is getting absurd....
Peace, Forged

theres realy no other advice needed but my mine..
not kncoking anybody else but there all unecessary steps

after years of injecting it becomes very difficult to get the oil in you..

 

[forged71]

theres realy no other advice needed but my mine..
not kncoking anybody else but there all unecessary steps

after years of injecting it becomes very difficult to get the oil in you..

I wasn't trying to be rude, but taking the plunger out 1. Ruins the seal and greatly increases the risk of a blow out. 2. It also lets any particles germs etc. enter while you swap back and forth.. I've been running for 20 years and have never had a problem with injections. Just the pinz your use too bro and rotate injection sites to allow heal time like RADAR stated....
Peace, Forged

 

[gstacker]

Na my advvise is the best lol

 

[HAYEZ]

I wasn't trying to be rude, but taking the plunger out 1. Ruins the seal and greatly increases the risk of a blow out. 2. It also lets any particles germs etc. enter while you swap back and forth.. I've been running for 20 years and have never had a problem with injections. Just the pinz your use too bro and rotate injection sites to allow heal time like RADAR stated....
Peace, Forged

ed injects for years make it difficult for some to inject..my delts shoot the oil back out...
swapping pins is no diff then drawing from a glass amp...

 

[gstacker]

Not much diff from a 27g 5/8 and a slin...
1/2 inch is like borderline deep enough, that's why if I do use a slin I'd burry the pin in my bicep and that's if I'm running low on pins... Buy em local at rite aide
other than than, I'll stick to 27g