Brewing problem

[tylersburden]

I brewed my Test E batch and put too much BA in it I beleive. Every time I pin My leg swells up and is in pain for 4 days or so. Pinned my glute and it is even worse. Was told to put in oven with needle in top.

Stupid over here for got to take the little plastic off the end of needle. It melted away. Any thoughts of it getting into the gear?
Is my batch bunk? Did I develop a cyst in my glute or just a mild infection?

 

[bob3342]

i doubt it dripped in unless you were using a 15g that plastic is two thick an because of the heat the flow of air is out not in the vial so unlikly anything went in an for everything else id be guessing an geussing is just another form of lieing

 

[tylersburden]

thats good to know. I hope my glute is ok. swelled up like no other man.

 

[zedhed]

I agree with bob. Should be ok from that standpoint...

 

[goin on 4T]

The swelling is not from the BA that is a myth. The swelling is from a nonsterile issue.
Baking the gear will cause ALL of the BA to come and now you have to add BA back to the vial. But you have no idea if all of the BA disapaited in the oven experiment.
You need to autoclave your vial. Baking will not sterilize your gear.
So you have 3 options:
1. Run it anyways and risk it
2. Autoclave it an know your good to go
3. Toss it in the trash