Boiling test

[viagraboy]

I seem to be having a hard time with this brand of test im taking. Me and my friend both had severe pain, redness, and swelling. His is gone after six days and mine is still there. I think I may be sensitive to high levels of BA. My other friend suggested putting a pin through the stopper, submersing in boiling water, and letting the BA or alcohol steam out through the pin. Any thoughts on this one. I cant spend 12 weeks limping around. Thanks.

 

[cbrod213]

Me and my friends are having the same problem with a certain lab's test. I tried baking it and it diidn't help. I even threw deca into my cycle thinking it would help, but it didn't. I''m in need of some help too. Any other suggestions.

 

[mixxin]

I read on another forum that you have to heat the oil to 450 degrees.

 

[envies]

it depends on the type of test. test enan has a low boiling point of like 100 degrees, so you will risk ruining the hormone if you try and heat that up to around 150 or so to get rid of some BA. Look for a chart of boiling points for the type of test you have and dont go over that temperature. Also is this your first couple shots? I had a lot of pain for about a week when I did my first shot, the next shot was a lot less painful and the third was a piece of cake.( for the same site)

 

[Mr. Burns]

No pain no gain. Take a warm shower and loosen up. Rub that shit around and mix it up.