boiling out b/a

[The Bigfella]

would increasing the oil concentration aid in site irritation reduction, for example pulling an extra CC of oil from say a bottle of sesame oil and mixing it with your painful gear help, yes it would make a 1 cc injection into a 2cc injection, but u would have less pain and proper dosage,....well as proper as u could get with ttokkyo crap

Yep, it is better to mix with any other steroids as well as this also dilutes the BA content overall in the shot and eases the pain a little.
You can bake it without ruining but do not boil it, it will still give of BAvapours at below the boiling point, which will help a little, then just dilute with other oil or a combo with another steroid. Better than wasting it bro..........

Bigfella.

 

[swampmoose]

re

if your getting sick, you might want to try supplementing with a few grams of vitamin C or other antioxidants. C is the cheapest and does wonders for me. havent been sick since. IMO

 

[Sigmund Roid]

Ok, here is the solution:

Oil, BB and your steroid are very poorly soluble in water, but water can handle 4% BA. So what you do is to poor water on your oil, say you have 10 ml 10% BA, that is 1 ml BA, you need 25 ml water. Preferably the water is sterile and contains some NaCl (table salt), say 1.25 grams in 25 ml water. You shake very very well and wait for separation. Then you take out the oil fraction, and viola, you have what you need. There will still be some BA in the oil, but a lot less.

BTW, if too much BA is taken out of the oil, your steroid might precipitate and you don't want that! Maybe start with 10 ml water per 10 ml oil?

 

[Spidey]

Ok, here is the solution:

Oil, BB and your steroid are very poorly soluble in water, but water can handle 4% BA. So what you do is to poor water on your oil, say you have 10 ml 10% BA, that is 1 ml BA, you need 25 ml water. Preferably the water is sterile and contains some NaCl (table salt), say 1.25 grams in 25 ml water. You shake very very well and wait for separation. Then you take out the oil fraction, and viola, you have what you need. There will still be some BA in the oil, but a lot less.

BTW, if too much BA is taken out of the oil, your steroid might precipitate and you don't want that! Maybe start with 10 ml water per 10 ml oil?

That is a sound idea. Why didn't I think of that.

-Spidey

 

[Punt]

bump this up

 

[Punt]

This is a recurring topic, lets hear some more input/thoughts.

 

[Spidey]

I think Sigmund answered the question quite nicely. It's hard to imagine a better or easier solution than he gave.

-Spidey

 

[Mr. Las Vegas]

I have had this problem with Mexican gear before. What I did was: Fill the syringe with the steroid. Take off the needle and stick a toothpick in the hole where the needle goes. Microwave it on high for 45 seconds, then run it under cold water until it cools. Heat and cool it three times and it should be fine.