Best technique for heating gear...

[Hexagon]

I just let the vial sit in front of the vent on my laptop. This increases the viscosity just enough for painless easy injections.

 

[wootoom]

why bake??? i dont get the pupose

 

[Burpees]

why bake??? i dont get the pupose

baking sterilizes the solution, it also breaks down any solids, and depending on the oil/compound could lower the viscosity a little bit.

for the average person, warming the oils in hot water is plenty for an easy injection.

 

[Brad87]

I bought a small heating pad at Wal-Mart. Before I inject every morning I wrap up my vials in the pad and leave them there for about 10 mins. Everything is good after then.

 

[juicyjuice85]

I allways just put the vial in a pot of hot water you can also stck a pin in the top to relase any pressure that might build up while heating

 

[jcnuts]

Why don't you just bend over and jam the vial up your ass for 10 min it will warm it up.

Sent from my EVO4G.

 

[UA_Iron]

Run the syringe with cap on the barrel under hot water. With teh cap it wont get wet. Dry off and then pull the cap off and shoot.

Heating pads, hot plates, ovens? How long does it take you guys to inject in the morning? An hour?

 

[RADAR]

Why don't you just bend over and jam the vial up your ass for 10 min it will warm it up.

Sent from my EVO4G.

lololololol! This made me loose it lol!

 

[RADAR]

A hair Dryer works best! load the syringe and warm,Heating the vial multiple times will break down the BA content!