Please Scroll Down to See Forums Below
Best technique for heating gear...
- Thread starter tonyroma
- Start date
ur2insecure
New member
The easiest way is to bake the gear:
Put a pin in the top (just pin , NOT syringe)
pre-heat oven to 175 F^o
bake for 10 min
let cool for 30min
(repeat 2-3 times).
PLEASE USE A GLOVE FOR YOUR OWN GOOD
I found this info ^^^^ on a previous post.
I have tried it it did work but only a little, you can also cut it with other gear or sterile oil.
Put a pin in the top (just pin , NOT syringe)
pre-heat oven to 175 F^o
bake for 10 min
let cool for 30min
(repeat 2-3 times).
PLEASE USE A GLOVE FOR YOUR OWN GOOD
I found this info ^^^^ on a previous post.
I have tried it it did work but only a little, you can also cut it with other gear or sterile oil.
ur2insecure
New member
Looking at your current course - what are you trying to bake?
ur2insecure
New member
wags8 said:
Enlighten me please?
tonyroma said:
Place vial (with needle, not syringe, inserted to equalize pressure) in a pan of water to about half the height of the vial. Bring water to the softest boil for 20 minutes. Watch the water level.
This fixed my Stealth inj. pain problem. I store Stealth in used, sterilized vials.
-1crow
glennds
New member
when my gear starts to crystallize, i.e. test cyp or NPP, i boil some water in a saucepan and pour about 1.5 inches into a coffee cup. i then immerse the vial for a few minutes where it will liquefy perfectly. it then injects very easily.
dont know about baking...seems too risky that the vial would explode. but never tried it so dont you all jump all over me, goddamnit.
dont know about baking...seems too risky that the vial would explode. but never tried it so dont you all jump all over me, goddamnit.
Similar threads
