Amp drawing

[Stacemranger]

When drawing from an amp, in my case it will be two amps total per injection, do I need to change the needles? Or is the needle still sharp and good to go?

 

[sweed]

i draw with 20 and swtich to 23 g .. te glass could dull the needle a little

 

[Stacemranger]

That's what I thought, wasn't for sure. Thanks sweed.

 

[Mr.X]

When drawing from an amp, in my case it will be two amps total per injection, do I need to change the needles? Or is the needle still sharp and good to go?

Use 18g to draw, fast and easy. Change needles after you draw; always use a fresh pin for injecting.

 

[swordfish151]

Like sweed said, the glass could dull it slightly...but to be safe always change it before injecting..

 

[Stacemranger]

Yeah, I drew it. Took forever though through a 23.

 

[gregy0]

yeah man im new to the game but hers what i did , i used a 18g to get it out . 5 seconds tops switched the needle then i was good to go.. 23g 1" to inject PAINLESS

 

[OZ23]

they are all correct. The pin will get dull from the glass. You might barley touch the sides or the bottom of the glass amp and just that will cause it to get dull. Try using that pin and you will realize how much better it is to put a new pin on.

 

[digimon7068]

When drawing from an amp, in my case it will be two amps total per injection, do I need to change the needles? Or is the needle still sharp and good to go?

I always use a bigger one to draw just to accelerate the process and a smaller one to shoot (less pain, etc.).

That said, I used the same one for both (draw and inject) once and the damn thing was so dull from scraping it around on the bottom of the amp that, breaking the skin was a bit of a challenge Needless to say, it wasn't one of my more pain-free injects.

 

[AMGETR]

Use same needle for drawing from both amps. Change needle for injecting