Adding cottonseed oil to prop

[needtogetarmy]

grapeseed oil has the lowest viscosity (it is the least thick) out of all of the oils so I recommend that.

Also, heating the vial in warm water (do not submerge it) just fill up a coffee cup with hot water and place the vial in it for a few minutes (make sure the top of the vial is above the water). Also, placing the vial in a heating pad is good (it takes longer to warm). Warm gear disperses in the body quicker and mitigates the pain.

I always filter my gear/oil no matter what. What I would do is mix the oil and gear together and refilter it into a new clean, sterile vial. I do not know the manufacturer of your oil but just because it says it is sterile doesn't mean it has been filtered (I assume it has). Filtering helps remove any foreign debris that is in oil. I take ZERO risk when it comes to injecting something in my body. I have read horror stories about abscesses and I would rather take the added precautions than risk an abscess.

 

[needtogetarmy]

On another note, and this is important, BA is the ingredient that neutralizes bacteria in gear. At a minimum it takes 1% BA to make the gear sterile. FYI I always use 3% when homebrewing.

Some gear comes with very low levels of BA. If you gear is 1% BA, and you mix it with oil (even if the oil is sterile) and say you use a 50/50 mix, you gear is now .5% BA and this is below the necessary amount to keep the gear sterile. Thus, if you mix in oil, you would also need to add BA to ensure the gear stays sterile.

Also, when you continually inject into the oil vial, the chances of foreign particles entering the oil increase. If there is no BA in the oil, it can easily go from being sterile to not being sterile. Thus, even if the first few injections go without a problem, bacteria could enter the oil and grow, causing you a ton of problems.

My recommendation for totally sterile gear:

(1) take the oil and the gear and add a little BA and mix it all together.
(2) get new sterile vials and refilter the new mix in the new sterile vials
(3) let it sit for a few days to ensure the BA does its job

Option (2)

Stop your bitchin' and endure the pain lol

 

[Big_Joe]

I have some 100mg/ml tren ace with 100mg/ml test prop gear. Using that straight just killed me. I mixed 10 ml of that stuff with 10 ml testosterone enanthate and 20 ml of sterile oil. Still hurt like hell. But if I heat it in boiling water them inject in my glute it's not so bad. Anywhere else and I'm a cripple. I don't heat the vial. I fill the syringe and put it in the boiling water. If there is no air in the syringe all the gear stays in the syringe. When it comes out of the water I change the point from the one I draw with to the one I inject with.

Currently I am using sustanon and tri-tren. I mix up a pin for each glut. SO I have about half a dose in each glute of the sus and tri-tren. I ten add to each syringe a little over one half ml of the tern ace and test prop mix. I do one in each glute and it still hurts like hell but not so bad I can't walk or train.

I have read that if you keep using prop your body will eventually stop reacting to it. Boy am I looking forward to that day.