25g 5/8 ok for quads and delts

[Steroid Guru]

How many of of you guys hit your quads or delts with 5/8 inch needles? I was thinking about using them for my upcoming cycle which requires ED shots.

 

[Cutt29]

depends on how much bodyfat you have

 

[Vascular Freak]

I use 1.5" for quads, 5/8 is too short.... fine for the delts though

 

[justinjones1963]

I use 1 inch all over with 23g.

 

[Cutt29]

I use 1 inch all over with 23g.

same

 

[bw1]

same

Yep

 

[solidspine]

I have always injected 1 inch needles in the quads, 5/8 may work, just may,

Assuming you have zero fat, ¾ inch would be just a hair better, but if you have 5/8 give it shot, no pun intended.

 

[buffalo]

I use 5/8'' for quad shot's,never have had a problem,you do need to have very low bf% though.

 

[Steroid Guru]

I use 5/8'' for quad shot's,never have had a problem,you do need to have very low bf% though.

Well im not shredded, but im not a fatty either. Probably just average, whatever that is. I think I will give it a try though.

 

[get456]

i noticed a huge difference going from a 1in pin to a 1.5 for quads... I had never had an issue before but when i moved to 3cc into the quads instead of 1 or 2... going deeper helped immensely

5/8 to me is not enough for quads unless you are SUPER lean and not injecting much... if both of those are the case bis/tris/delts are all better places