Ethyl Oleate ~ some basic info on using it

[bigtravis]

Travis:
I am learning and reading and have some basic questions.
1. I think I understand what BA does, keeps it sterile?
2. What does the BB do?
In regards to mixing Test Ethanate
3. If using EO oil what is the other oil you use? GS, CS or just all EO?
4. Is the reason for useing the filler oil due to the cost compared to EO?
Thanks bro

I have used EO and BA as the only other two elements other than the compound itself, BUT only to each compounds threshold.

And yes the mix of GSO/EO is due to cost. This mixture is still thin enough to draw 3ml.with a 25g. pin in about 1 minute.

 

[jediclampet]

I keep reading about how EO eats up the filter causing the product to be cloudy. How can EO be used if it damages the filter? Obviously having a sterile product is essential.

 

[jediclampet]

I keep reading about how EO eats up the filter causing the product to be cloudy. How can EO be used if it damages the filter? Obviously having a sterile product is essential.

OK, I found the thread about filtering EO so I guess the answer to my question is to change filters every 20 ml.

I plan to make masteron enan at 250 mg/ml. I use .45 um whatman filters. I guess I will use 35% EO and not use the same filter for more than 20 ml. Does this sound good? Any advice/input?

 

[scottac78]

I have also heard of filtration problems with ethyl oleate. I would like some more info on this as well.

 

[sekstoiz]

argh... i just started filtering a large batch of EO Sustanon and had a filter meltdown. is there a more expensive type of filter i can buy to handle this. a new filter every 20ml will take forever and cost a fortune. =(

 

[goin on 4T]

Use the .20 whatmans and a 60ml syringe with a caulking gun, and don't use a cheap caulking gun. The best way to do it is to filter your stuff before you add the EO and filter the EO seperately then mix the two over heat.

 

[sekstoiz]

How can I filter the EO separately when it destroys filters with only 50% concentration? I had high hopes for using EO, but I think I may be done with that notion!

 

[goin on 4T]

Filtering seperately was an option that was givin to me. After a second batch of 100/100/100 tren ace/test prop/masteron with a 50/50 GS/EO oil doesn't seem to be necessary. The key is how long the oil is in the filter that is your window of how long till the filter fails. 20ml is too short. Did 100ml twice and they look beautifull! Now off to the lab to see if powder was real!