dirt or something in my vial.............

[mighty-musculus]

So I transfer my test E from plastic jugs to glass vials, and I noticed 3 smalls pieces of dirt in my vial. As long as I dont draw it up I'm thinking I'll be fine. That being said any advice would help.

 

[SofaGeorge]

Yeah... and if those little specs are mold you will be injecting vegitation into your blood stream that can colonize in your heart.

Your choice.

People don't realize it, but dirty juice is killing people. For years heroin addicts used dirty water, and many had problems from it.

There is a reason pharma labs put so many steps into sterilizing injectables.

 

[access]

Run it through a whatman filter at the very least before using.

 

[mighty-musculus]

Thank you for the responses, I never even considered mold. I'm ordering the filters now, should I also add Benzyl Alcohol and if so how much for a 20 ml vial.

 

[Kempona]

So I transfer my test E from plastic jugs to glass vials, and I noticed 3 smalls pieces of dirt in my vial. As long as I dont draw it up I'm thinking I'll be fine. That being said any advice would help.

Did the jugs have rubber top? If yes it could be some robber pieces. Don't draw it up, but I guess ur making your stuff so should be familiar with any kind of procedure , so filter it just to be on the safe side.

 

[wolfman87]

you could send it to me and i'll check it out for ya! lol jk

 

[RADAR]

Or It could be contaminents, even a filter cannot filter microbes! So it looks like russian roulette from here.
I've beem doing this 38 yrs and am still amazed at the posts i see, I have NEVER gotten junk in any of my gear!


RADAR

 

[access]

I tend to think it's rubber Radar but your absolutley right and we should never take short cuts where our health is concerned. I just seem surprised he didn;t notice it in the jugs before transferring to vials as generally it is not hard to miss something something in a jug of gear that should not be in there. The fact it appeared after the transfer as it seems leads me to think it's rubber.

 

[HaZaRDouZ]

Or It could be contaminents, even a filter cannot filter microbes! So it looks like russian roulette from here.
I've beem doing this 38 yrs and am still amazed at the posts i see, I have NEVER gotten junk in any of my gear!


RADAR

Aren't you the lucky one? I'm one of the many who goes through source after source trying to find the one I can stick to. Very frustrating, quality nowadays is disappointing.

 

[mighty-musculus]

Thankyou again for all the advice. I did not notice any specs in the jugs before tansferring to vials, but to be safe I've already ordered filters and vials and plan to bake them. The specs have not grown or multiplied which leaves me to believe it is rubber, like others have stated.

 

[access]

Good to know..be safe mighty-musculus and good luck with cycle!

 

[mighty-musculus]

well, here is an update. I filtered the test with whatman .45 and the dam peice of rubber went right through it. I was still able to get the rubber spec out of the new vial with a needle and syringe. Anyhow I baked and injected, after it cooled lol. So far everything seems to be going well, I wont tell you if I die.