Test prop crystalized... Wat do?

[JuiceIsMyFriend]

Ok guys so I just got my order of eq and test prop in today. The prop is crystalized. The eq is fine. Never had this happen before. Don't plan on starting it for 2 weeks. If I leave it in my warm closet till then will it be okay? Please give me detailed instructions on how you've handled this before. Like don't just say heat it up. Tell me how you heat it up. Run it under warm water etc. ?? Don't be vague. Thanks. Also sorry for shit image quality

 

[RADAR]

Heat it with a blow dryer when you get ready to use it,should fall back into solution.

 

[bender19]

you can warm it up in a pot of hot water or bake it in the oven on like 250 degrees for like 15 mins. My bro had to do this, he baked it in the oven, think you got to put a pin in it to releive the pressure or it will bust. you will have to keep doing this most likely till its all gone

 

[bender19]

or do what radar said lol

 

[JuiceIsMyFriend]

Heat it with a blow dryer when you get ready to use it,should fall back into solution.

Awesome. Thanks god of gear. You should look into trade marking that name lol. Your knowledge is never ending bro.

 

[bluetwistedsteel67]

Key is to use as little heat as needed to get it back into a solution. It may stay in a solution or it may just keep crashing. Blow dryer should work, if not place it in some very hot water. Oven is a last resort and you won't likely need that.

 

[JuiceIsMyFriend]

Thanks guys

 

[JuiceIsMyFriend]

Alright broskis I stuck my bottle in a pot on the stove with a needle sticking out of top to vent. Filled pot where water was just up to neck of bottle and slowly brought water up to almost a boil. Let it sit 5-10 mins almost at a boil then sloshed it around and sat it back in water another 5 mins. Sloshed oil around bottle again to get all the crystals up around the top of neck and it was good to go. 8 hrs later and it still seems to be set. Will still warm it up before injections but thought I'd let y'all know. Thanks for all the help

 

[RADAR]

Alright broskis I stuck my bottle in a pot on the stove with a needle sticking out of top to vent. Filled pot where water was just up to neck of bottle and slowly brought water up to almost a boil. Let it sit 5-10 mins almost at a boil then sloshed it around and sat it back in water another 5 mins. Sloshed oil around bottle again to get all the crystals up around the top of neck and it was good to go. 8 hrs later and it still seems to be set. Will still warm it up before injections but thought I'd let y'all know. Thanks for all the help

Remember too much heat destorys the BA content

Thats why i recommend a hair dryer!

 

[JuiceIsMyFriend]

Remember too much heat destorys the BA content

Thats why i recommend a hair dryer!

Yeah that's why I slowly raised the heat. It seemed like the hair dryer just wasn't gonna get it hot enough. It's a 50ml bottle