Vial??

[Ramcononer]

after you push through the rubber stopper you leave a little hole. Should you keep putting into that same mark everytime you draw? Or should you just move it a bit? Thanks

 

[nicecannons]

dont really matter.but before i put needle in to draw up i always wipe the top wiyh a sterile wipe.the holes should re seal if they are genuine

 

[AhMadKooL]

dont really matter.but before i put needle in to draw up i always wipe the top wiyh a sterile wipe.the holes should re seal if they are genuine

What he said ^^^

 

[Ramcononer]

This is def. Genuine but you can still see a little mark where the old pin was. I also do wipe the top. My question is should I aim for that little mark?

 

[nicecannons]

no real need to but you wont harm the rubber by doing so

 

[Apexx]

I use a larger gauge pin to draw with so I usually keep moving the site around on the stopper. If you keep pushing a large needle through the same hole, there is more of a chance to rip or enlarge it. Don't know if this applies to you though.

 

[Ramcononer]

im drawing with a 20 and injecting with a 23.

 

[njmuscleguy]

I use a larger gauge pin to draw with so I usually keep moving the site around on the stopper. If you keep pushing a large needle through the same hole, there is more of a chance to rip or enlarge it. Don't know if this applies to you though.

yup, what apexx said.... I use an 18g, and that sucker can tear up the rubber stopper... so I try to move it around each time

 

[Ramcononer]

Thanks guys.

 

[dsh89]

It is made to seal itself up again. But moving it a bit each time doesn't hurt. And no I am not saying the rubber magically repairs itself. It is a multi-dose vial for a reason though. GL!