Please Scroll Down to See Forums Below Sure, you could do that, or since it's already in the other syringe, just squirt 5ccs into the smaller syringe. Either way you do it is fine.
Urgent!!!!making Fina Wtf????!!!!!
- Thread starter CB38AC
- Start date
I don't fully understand, but it sounds like you lost the seal on the syringe because the pressure exerted was too much.
It sounds like you either need to put on a new filter or something. It's hard to filter, but it shouldn't be that hard. Maybe you just got a crappy filter. That's happened to me before.
It sounds like you either need to put on a new filter or something. It's hard to filter, but it shouldn't be that hard. Maybe you just got a crappy filter. That's happened to me before.
serge
New member
disolve in the solvent, add into the oil, let stand so all the glue and binders drop out, draw out the clear solution, filter through, take the leftovers from the bottom, filter them through coffee filter, then through the syringe filter, heat up your final product and shake, then you are good to go
rouleduke777
New member
Dude you are WAY too anxious about this. It sounds like you were worried way before you even started. It is very easy, the more confidence you have the easier it goes. As far as the oil coming out the back of the syringe, you definately fucked something up!
Oxydization is colorization due to commining in contact with oxygen, you cant filter it out. The hour time limit many directions show is not an issue. Worse case scenario your final product is a little dark. I let mine dissolve over night everything is fine.
trenbolone acetate melts at approx 196degrees, and water boils at like 220 or something. Best way to heat it and not worry about overheating is place water on a burner and boil the water, once at a rapid boil, remove from burner and set vial in water. That way you know(removed from burner) you should not overheat it.
