test e injenction

[gymjunkie09]

How long does the vial need to be heated with the hairdryer for before injecting?

 

[NeedMore]

First, tell us why you are needing to hea tthe vial. Not sure if your brewed your on AAS or what

 

[gymjunkie09]

First, tell us why you are needing to hea tthe vial. Not sure if your brewed your on AAS or what

Idk...Cause that's what the directions said that came with it bro, lol

This is my first cycle

 

[FLEX4USML]

Dont use a blow dryer,use a spoon and a lighter!

 

[FLEX4USML]

JK.....E shouldnt need to be heated,if anything run the vial or barrel(not the needle and not the stopper on the vial aka rubber thing on top),under warm water for a minute.

 

[jb160]

JK.....E shouldnt need to be heated,if anything run the vial or barrel(not the needle and not the stopper on the vial aka rubber thing on top),under warm water for a minute.

Yes just load the syringe and run under hot water. That will thin it out to inject smoothly.

 

[gymjunkie09]

Dont use a blow dryer,use a spoon and a lighter!

Lmao, ur a funny dude. Appreciative the advice bro

 

[bobby6638]

or just boil some water,, when done put it in a seperated cup or bowl,, put vial in for a minute or so Then draw from vial, i like it this way no chance of any water getting near pin before injection... JMO

 

[TONY83]

Throw it away and find another source where you dont have to heat anything!! Man i miss those good old days of plentiful quality vet gear!!!!! AMEN

 

[captainahole]

Dont use a blow dryer,use a spoon and a lighter!

lolololololololol

 

[kx250rider]

Something is odd, if there are "instructions" with it, and if it needs to be heated. Maybe they're just trying to get it thinner so as to use a smaller needle, but if it's too thick to use at room temp with a normal 22 or 23 g needle, I'd be very suspicious of the source, unless you're posting from Antarctica or Siberia!

BTW: I'm not intending to make fun of the question... You're smarter than many people, to be asking in the first place!

Charles

 

[gymjunkie09]

Something is odd, if there are "instructions" with it, and if it needs to be heated. Maybe they're just trying to get it thinner so as to use a smaller needle, but if it's too thick to use at room temp with a normal 22 or 23 g needle, I'd be very suspicious of the source, unless you're posting from Antarctica or Siberia!

BTW: I'm not intending to make fun of the question... You're smarter than many people, to be asking in the first place!

Charles

Na I'm 99.9% sure the source is solid, it jus came with a piece of paper that said to heat the vial with a hairdryer and wipe the injection site and the stopper with rubbing alcohol before injecting then massage injection area after