test c homebrew

[pher143]

Hey everyone went to make some test c last nite and used same recipe that you would for test e. Everything fine but went to filter it and it clumps up into gel like in gao. Anybody have any idea what went wrong? Making 60ml at 400mg with 2%ba 18%bb 40 ml gso ..thanks

 

[pher143]

sorry guys didnt go down far enough down page saw another thread on this.....

 

[Mh48500]

The other thread has a 250mg/ml recipe...you are trying 400mg/ml. I am guessing the mg/ml concentration is too high.

I attempted test prop over the weekend at 200 mg/ml and failed miserably. I use a lot lower of BB % than you(just personal preference) but still at some point the hormone will just not hold at too high of a concentration. I have read a lot about how high you can go, but I guess I wanted to see for myself. There are not a ton of homebrewers and sometimes people repeat what they have read and never actually tried it, so I went for it. There are definte limits.

Some UG put out very high dosed mixes and frankly they are most likely underdosed because at some point even with a ton of solvents the formula will not work.

Good luck!

 

[pher143]

yeah i thought the mg/ml might be the problem..i am going to try lower mg and see what happens...thanks bro...

 

[smartlooker_]

250 mg/ml is the highest it can go without eo. also, consider heating it long enough because test cyp has a high melting point. i crashed one batch and found that baking for 2hours and 15 minutes gets rid of the problem.

 

[sony190]

400 cyp waaaaay to high bro. If your set on trying it at that high of concentration use 50eo 50 gso heat min 30 min : /

 

[goin on 4T]

never get it, just cut in half with the GS and you will 200 which is easy.