Suspension

[Singleton]

How do you use it?

Here's How I run it:
100mg (50mg bilaterally) into the muscle I am about to train 20 min prior to training. (e.g. 50mg into each pec on chest day)

This makes me very sore -- no doubt from the test causing damage to the muscle. I get a very deep, but good soreness from it.

Clogging: My problem
Clogging is the most annoying thing. 23g gets clogged. I heat the suspension by putting it in a glass of hot tapwater for a few minutes and shake it well, but I often get clogs.

 

[Güclü_oglan]

How do you use it?

Here's How I run it:
100mg (50mg bilaterally) into the muscle I am about to train 20 min prior to training. (e.g. 50mg into each pec on chest day)

This makes me very sore -- no doubt from the test causing damage to the muscle. I get a very deep, but good soreness from it.

Clogging: My problem
Clogging is the most annoying thing. 23g gets clogged. I heat the suspension by putting it in a glass of hot tapwater for a few minutes and shake it well, but I often get clogs.

bro hotwater won't do shit, boil up water in a saucepan and bring to a boil and then put the pan aside and dip the vial in there and it will get nice. Just make sure you don't inject boiling hot suspension because that can hurt

 

[muscleup]

suspension is notorious for this......There are certain UG suspension that don't clog at all ,and go through a slin pin.

 

[monkey arms]

I mix mine with what ever oil I'm shooting. Works like a charm. I know people say you shouldn't mix oil and water, but I've been doing it for a long time and havn't had ANY problems.

I.E. 1cc suspension mixed with .5cc steril oil, test cyp, tren, eq, deca, etc. Once you have both in the syringe, pull back to let some air in, and shake the piss out of it. It will mix well if heated but don't over do the heat, just get the oil to flow. Push the air out and you are good to go.. I use22's but it should go thru 23 and 25's as well.