screw this, I'm quitin' roids

[mvmaxx]

Just my 2 cents but I'd start using gear that was a little easier in the pain department (ie decca or eq w/your test). All I can tell you is I shoot up my Organon Durateston (sust) with decca using a 23gauge 1-1/2" and I literally forget which glute I stuck.

 

[KENNY3]

1" 25 ga pins

2cc's eod

alternating right quad, left quad, right glute

both tren and test converted using A's kits

substituted converted synovex for the oil in the finaplix conversion to cut down on oil, so i get 304mgs of gear in 2cc's

I also warm my syringe under warm running water for about two minutes before injs

tri's and shoulders just freak me out, even if i could do a one handed injection, I probably couldn't drive for the next 4 days

 

[Slider]

Ya, leaving the pinz in are bad...Ha, ha.
Seriously though my brother had the same prob and it boiled down to no more shots in the legs and he got a lighter massage on his legs, his massage therapist was going to deep in the fibers. It don’t take much pressure to go deep in the fibers on legs, which will cause you to walk like you just got poked by a big dude in the ASS.

Try leaving your legs alone for awhile.

Kev

 

[Kid Blast]

BTW- I'm not using sus, its converted synovex

2cc's gives me 142g test / 162g tren

Did you convert this yourself or buy it finished? Who's kit did you use? It's probably causing tissue necrosis from too much BA.

You should junk this stuff and get some human grade gear. That way you can do gear and actually walk at the same time.

 

[Kid Blast]

1" 25 ga pins

2cc's eod

alternating right quad, left quad, right glute

both tren and test converted using A's kits

substituted converted synovex for the oil in the finaplix conversion to cut down on oil, so i get 304mgs of gear in 2cc's

Sorry, bro. I missed this post.

I stand by my diagnosis. Too much BA + only 3 days recovery time per body part + 2 ccs per shot = severe pain and possible necrosis.

You could try glute, glute, quad, quad or just bail on this stuff and get some better gear. (You really my be somewhat allergic to the BA.)

 

[KENNY3]

tissue necrosis

that sounds scary


I tried baking my gear at 225 degrees for 10 min twice
to help lower the BA content (obviously its very high)

should I do this a few more times?
I have to assume its the high BA content thats causing the problem.

does anyone know of a better way to lower BA?

 

[johnboy]

tell me you didn't.....

Those implant guns hurt like a bitch don't they.

Tell me you haven't been doing this.

 

[KENNY3]

no

i only use the implant gun for forehead injections

 

[mvmaxx]

1" 25 ga pins

2cc's eod

alternating right quad, left quad, right glute

I have yet to use tren so the only thing I can say is listen to the guys that have. But I will tell you one thing based on experience. If you're using 25gauge 1" for your glutes it's not long enough. I used a 23gauge 1" for my first 2 injections (before I placed my order to getpinz.com) and my ass hurt for at least 3 days. It hurt to sit down and I had a major cramp in my ass. Once I got my pinz and started shooting 23gauge 1-1/2" there was absolutely no pain afterwards.
Get some 1-1/2"ers dude.

 

[Krazzylad]

U need to use human grade gear