same needle to inject as draw?

[granby140]

What do i do here? use a new one to draw as to inject? its gonna be for EQ...

 

[gilly6993-recreatedbygeorge]

I always use a new needle to draw and a new needle to inject. That's just me though, I'm sure you'll get varying opinions

 

[genarr3]

You should use a drawing needle and an injecting needle.
1) It's cleaner
2) You won't dull your injecting pin
3) It's cheap
4) You can use a bigger pin on the drawing phase
5) You can use a smaller pin to inject

I've done them both ways, but there is no good reason not to use a second pin.

 

[JC Grifter]

[there is no good reason not to use a second pin. [/B]

Exactly! its safer,less painful (needles get dulled from going through the rubber) and they are so cheap

 

[Ercole]

Just pushing it through one rubber stopper can dull a pin so that it will make a bigger hole in you and hurt like hell. Always use a fresh needle to inject.

 

[CycloneHWT]

bro i have done it both way, and it doesnt make a difference... the needle doesnt exactly hurt either way bro, even the 18 gauges arent that bad

Cyclone

 

[Audio8]

when i change the needle, it just sinks through the skin like butter...but if i don't, it's painful, but tolerable. just not as fun when it feels like the needle is breaking through 20 layers of skin.

 

[boss]

You should use a drawing needle and an injecting needle.
1) It's cleaner
2) You won't dull your injecting pin
3) It's cheap
4) You can use a bigger pin on the drawing phase
5) You can use a smaller pin to inject

I've done them both ways, but there is no good reason not to use a second pin.

again i 100% agree.........ercole your a pussy!!!!.........j/k

 

[Willyumyum]

Yeah, the needle will suffer some dullage when you are fishing around in the amp to get every drop of the gear or poking through the stopper to a vial... either way, I'd switch it up unless you don't mind a little more pain when the needle is going in...

YUM

 

[Audio8]

Nothing worse than stabbing yourself with a dull pin

yes there is..stabbing yourself with a sharp pin, but pushing Ttokkyo sust through it.

 

[XBiker]

I always switch to a fresh needle after drawing.

The rubber septum dulls the needle and a fresh one penetrates the skin much easier.

Check out www.getpinz.com for all your needle needs.

 

[Keep it beefy]

i was on a severe needle shortage last cycle (couldn't order any), so i used the same needle to draw eq, and make two injections. i typically wen through 12mls of eq with only two needles.

and it did not ''hurt like hell''

it was just annoying trying to keep everything sterile the whole time.

 

[IronFist]

You should use a drawing needle and an injecting needle.
1) It's cleaner
2) You won't dull your injecting pin
3) It's cheap
4) You can use a bigger pin on the drawing phase
5) You can use a smaller pin to inject

I've done them both ways, but there is no good reason not to use a second pin.

I agree, injections are alot easier with new needles that haven't been through the rubber stopper...

 

[GameBreaker]

18? i don't mean to sound like a pussy but u can even tell the difference between the 25 i use for b12 and the 22's i use for my sust...18 would seem like a friggin harpoon