Please Scroll Down to See Forums Below
safety
- Thread starter dimi3
- Start date
Read up on it. If you know what you are doing and take all the precautions you will be ok. I have made my own batches several times and havent had any problems. Always had great results. But I spent countless hours looking up info to make sure I knew what I was doing. You can never be to safe when your health is on the line. That being said it is dirt cheap.
this is one solution i found so far. it seems almost easy enough, but there are still questions in the back of my mind.
Test Enanthate 5 gram conversion
Needed
5 grams test E
1ml Benzyl Alcohol = 5% BA
15.25 ml sesame oil
Syringes 3cc & 5/10cc
18 or 20 gauge needles
mixing Vial
Sterile Vial
Whatman sterile filter
1. Weigh out 5 grams of powder.
2. Place powder in vial.
3. Add BA to the vial.
4. Heat oil in the oven to help sterilize it, heat to at least 212 degrees F. I usually heat my oil at 275 to be sure, I put the oil in a muffin pan, just fill one of the indentions this is plenty for these experiments. Also heat more oil than you need, as you will not be able to get it all out of the pan.
5. Add oil to the vial, save 2 ml of oil in the syringe for later. Gently shake vial.
6. Heat mixture if necessary. I like heating my powder products, by placing the vial in a frying pan, and placing it on the eye of the stove.
7. Place a 18 or 20 gauge needle in the sterile vial attach Whatman sterile filter.
8. Place another needle in the sterile vial to relieve the pressure.
9. Draw out solution with a syringe, run though Whatman filter.
10. Take other syringe with 2ml oil, run through Whatman into solution.
Test Enanthate 5 gram conversion
Needed
5 grams test E
1ml Benzyl Alcohol = 5% BA
15.25 ml sesame oil
Syringes 3cc & 5/10cc
18 or 20 gauge needles
mixing Vial
Sterile Vial
Whatman sterile filter
1. Weigh out 5 grams of powder.
2. Place powder in vial.
3. Add BA to the vial.
4. Heat oil in the oven to help sterilize it, heat to at least 212 degrees F. I usually heat my oil at 275 to be sure, I put the oil in a muffin pan, just fill one of the indentions this is plenty for these experiments. Also heat more oil than you need, as you will not be able to get it all out of the pan.
5. Add oil to the vial, save 2 ml of oil in the syringe for later. Gently shake vial.
6. Heat mixture if necessary. I like heating my powder products, by placing the vial in a frying pan, and placing it on the eye of the stove.
7. Place a 18 or 20 gauge needle in the sterile vial attach Whatman sterile filter.
8. Place another needle in the sterile vial to relieve the pressure.
9. Draw out solution with a syringe, run though Whatman filter.
10. Take other syringe with 2ml oil, run through Whatman into solution.
Similar threads
