Quick!! Need FINA Help!!

[UnholyJoker]

Okay, I have the fina kit from Animal, that allows you to use two carts at once... which I am doing. However, I have read that I shouldn't let the stuff sit for longer than one hour, or else it will oxidize. Well, it has been an hour and all the pellets have yet to "melt." What should I do?

Thanks.

 

[DSPO]

What have you done so far???

 

[1Banshee]

What have you done so far???

Exactly we need more info!! The pellets will not disolve in one hour unless you use heat or totally crushed them...

 

[UnholyJoker]

Oh, then I guess I am in good shape, I emptied the carts into the magic solution, and have let them sit. I think they should be finished in about fifteen minutes.

Obviously, oxidation is a bad thing, so when do I know the stuff has oxidized?

 

[1Banshee]

If you don't have any visual reference look at this site below it shows in detail how the process works:

http://www.elitefitness.com/members/finaplix/make.html

 

[CrazyRican]

watch the color carefully, if it gets a very rusty,brownish color then it oxidized. to make it dissolve quicker stir the vial under hot top water for a few minutes and it will dissolve.

 

[DSPO]

Did you get a crushing rod from A? If so, Crush then swirl in warm water (not more than 100 degrees) for a few seconds...then crush more and swirl (Do not shake) until desolved. This process took me about 10 min. As far as oxidation this normally happens after 1 hour. I am going to eat but will check your progress in a few

 

[TxLonghorn]

I wouldn't worry too much about the oxidation thingy. Just warm the vial up in some warm water, and the pellets should dissolve relatively quickly.

 

[UnholyJoker]

Okay, I am done. I have a couple of questions, though. When I was finished using the needles to draw up the prefiltered stuff, I was left with some nasty brown shit at the bottom, it looked like caramel. Not much, but enough to notice. That's the glue, right. I wasn't supposed to do anything with that, right?

Secondly, the bottle with the little rubber stopper is almost full to the top (where the body of the bottle, starts to curve in) and it is a nice goldish color, looks like thick oily piss. that is good too, right?

Now for the dumbest question. I am planning on doing 75 ml? a day. I have syringes with CC's marked. So how many cc's should I do? (I feel like a complete moron asking that, but...)

 

[DSPO]

Brown stuff is glue that has stuck to the sides due to the majic solution....Discard

Gold color is what you want...good job

If you used A's 4gF kit with 2 carts then 1 cc - 75mg

 

[UnholyJoker]

thanks, DSPO.

Another stupid question, and for the record I have been searching on all these....

When should I shoot? Before bed, in the morning, before workout... Any suggestions.

 

[DSPO]

It does not matter...just be consistent...I shoot in the morning because I can't wait..heheheheh

 

[natass]

I just wanna say

that I think this was a great post. I like the sort of real time help here. Some boards don't let posts go through so fast so that others can get the help they need right then. GREAT BOARD!!

 

[mranderson]

Now you can take the glue, crap left at the bottom and strain
it through a coffe filter right just to get a tad bit more solution
is this worth it or not?

 

[nuh_mizer]

I converted mine last weekend too and used the same kit you had. My results were identicle. That was too easy.

thanks for the help Zyg

 

[nuh_mizer]

mranderson,
I tried that but realized it wasn't realy worth the effort. I ended up sucking the last bit of it up in the seringe along with some of the brown crap, then (since the brown crap always sinks to the bottom) I pushed the brown crap out and had the gold fluid left in the seringe.