Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

problems with homebrew test cip.

Mikey2005

New member
made some test cip, used 5 % Ba, test powder, sesame oil, 0.25 w-filter, heated oil to 275 degrees. Was nice and clear.

After 4 hours it looked like soap.

Any ideas? iam thankful for any advice
 
what concentration were you making? I am presuming you filtered it into a glass vial then stored it. If so where did you store it? when you say soap what is it that you mean? If you can answer that then I can help you out. my guess is that you will have to reheat it and it will be fine
 
add benzyl benzoate

i have seen that f'in conversion posted and reposted all over the internet- and it is not right- you need benzyl benzoate in this equation for test cyp. you can get away w/ not using it for some things (like test enan) but not test cypionate. add a cc (this will come out to like 10%) of bb to the vial, reheat, and it should hold. also, if the cyp sits in anything less than room temp. (below about 55 farenheit), or cools too fast, it will gum up and look like soap
 
ditto for me- this formula will work on just about anything within reason, and it shoots smooth w/ no pain w/ just about any compound (even 100mg/ml test prop)
 
I used Dazed solution and I only needed 1.5cc of BA added to it to make a 300mg/cc and I made 50ccs

I will now only use enanthate powder, as it is not as touchy. My buddy has it at 500mg/cc with dazed solution only.
 
ordered some solution from eagle research. they claim, that it works for long and short esters. I would appreciate
some advice if I could go up to 300 mg/cc for cyp. and 200/cc for prop. do I have to ad something else? or just solution and powder?
 
Top Bottom