Preloading pins

[enacer420nj]

Whats the procedure for preloading pins, just recap and put back in wrapper? How many days out would be the max for doing this? or would transfering to a sterile vial be more ideal if you were dealing with amps

 

[Olivelawn]

Whats the procedure for preloading pins, just recap and put back in wrapper? How many days out would be the max for doing this? or would transfering to a sterile vial be more ideal if you were dealing with amps

Load them with an 18 1 1/2" gauge pin and then remove that from the loaded syringe. Be sure to KEEP THE PIN INSIDE OF THE VIAL. If using amps I would assume you're loading the entire amp into the syringe?

Once in the syringe put on what ever pin you're going to use to inject with. No need to put it back in the wrapper.

You can load an entire cycle if you want. I wouldn't pre-load them until a week before you start your cycle though.

Transfering to a sterile vial just means there is more room for contamination, you want to move the oil as infrequently as possible.

 

[taoiron]

I pre-load a week at a time. I do put it back in the wrapper but that is probably not necessary.

Tao

 

[AAP]

Make sure your gear isn't made with EO because it has a deteriorating effect on the plastic and rubber of the syringe.

 

[enacer420nj]

You learn something new everyday! Thanks bro

 

[OMEGA]

sorry I am against it

just too many thing can go wrong

 

[HAYEZ]

I wouldn't do it..its one thing to expose it to air for a min before injecting. But to let it sit around is just to risky imo. I would just take the time and crack the amp when ya need an inject, I do transfer from 1 vial to another etc..see no issues with that

 

[small but working on it]

I never had any issues. I loaded whole cycle at once. I was using amps and used 18 gauge to draw and then twisted off and twisted on the 23 or 25 gauge(cap never taken off) pin back on and was good to go. I liked it because I was able to take my time and was super slow and made sure I was dead up sanitary and when I went to inject, I knew everything was clean. It was kinda nice seeing the syringes lying there together just waiting on me.

 

[bfq]

Make sure your gear isn't made with EO because it has a deteriorating effect on the plastic and rubber of the syringe.

What does that mean "made with EO"?

 

[enacer420nj]

What does that mean "made with EO"?

Ethyl Oleate a type of oil


MODS sorry for the double post I forgot I already made a thread feel free to delete the newest.

 

[deepveinthromb]

sorry I am against it

just too many thing can go wrong

i agree also. theres no excuse for it. youre just asking for an abcess or worse. youre exposing the atmosphere to your gear. theres a reason why the place sterile solution into sterile jars.