Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply US-PHARMACIES UGL OZ
Raptor Labs UGFREAK OxygenPharm
napsgeargenezapharmateuticals domestic-supplyUS-PHARMACIES UGL OZUGFREAKRaptor LabsOxygenPharm

Please help with hcg injections...

Anakin

New member
I want to inject 500iu every week throughout my cycle, the problem is that I have a 5000iu amp.
I know I have to use an insulin pin, but how the hell do I draw from that amp with the tiny slin pin that doesn't get to the bottom of the amp?
 
Try drawing up with a standard size syringe and pin and then pull the plunger completely out of the back of the insulin syringe and squirt the HCG in equal amounts into each insulin syringe. You of course will have to preload them, just make sure to store them in the fridge until you are ready to use them.
 
jh23 said:
Try drawing up with a standard size syringe and pin and then pull the plunger completely out of the back of the insulin syringe and squirt the HCG in equal amounts into each insulin syringe. You of course will have to preload them, just make sure to store them in the fridge until you are ready to use them.
i've got some HCG coming (i know check's in the mail same shit) but have similar ?'s...where do you inject HCG, is it intramuscular in the ass like other AAS or subq like slin/hgh ?
 
Just a side note....are you planning on storing the HCG with the solvent mix in the frig? If so, it won't be any good after a couple of days anyways. If you are mixing with bacteriostatic water:

1) Draw 1cc of BSH2O into normal syringe (22,23, or 25 gauge)
2) Open HCG powder amp
3) Inject the 1cc of BSH2O into amp (mixing the powder and liquid)
4) Pull contents of amp into syringe (1cc, still 5000IU's)
5) Put the 1cc BSH2O and HCG combination into a sterile vial
6) Draw an additional 4cc of BSH2O into the syringe (or 2X at 2cc's)
7) Inject this into the vial
8) You now have 5cc in the vial
9) Inject 1/2cc ..... this will give you 500IU of HCG
10) Refrigerate for next use

Hope this helps! Good luck!
 
LVTitan said:
i've got some HCG coming (i know check's in the mail same shit) but have similar ?'s...where do you inject HCG, is it intramuscular in the ass like other AAS or subq like slin/hgh ?
Intramuscular (glutes, delts, thigh, etc.) or SubQ...both are fine. I prefer glutes...and you don't need to get an 1.5" 22g either as it is not necessary to inject as deep as AAS. A 1" (or even 5/8) with 23 or 25 gauge will do!

Enjoy!
 
help4john said:
Just a side note....are you planning on storing the HCG with the solvent mix in the frig? If so, it won't be any good after a couple of days anyways. If you are mixing with bacteriostatic water:

1) Draw 1cc of BSH2O into normal syringe (22,23, or 25 gauge)
2) Open HCG powder amp
3) Inject the 1cc of BSH2O into amp (mixing the powder and liquid)
4) Pull contents of amp into syringe (1cc, still 5000IU's)
5) Put the 1cc BSH2O and HCG combination into a sterile vial
6) Draw an additional 4cc of BSH2O into the syringe (or 2X at 2cc's)
7) Inject this into the vial
8) You now have 5cc in the vial
9) Inject 1/2cc ..... this will give you 500IU of HCG
10) Refrigerate for next use

Hope this helps! Good luck!

Nice info ....exactly what I was looking for . Couple questions though.

1) Why cant you use the original solvent and just add the additional BW?

2) Who is the best source of presealed sterial vials to use for this?

K for any advice.
 
jcam222 said:
Nice info ....exactly what I was looking for . Couple questions though.

1) Why cant you use the original solvent and just add the additional BW?

2) Who is the best source of presealed sterial vials to use for this?

K for any advice.
1) The solvent deteriorates the life of the powder. It will only last about a day before losing strength. Just toss the solvent.

2) Best source.... www.getpinz.com. Order today (Tuesday) and you can have it at your home no later than Thursday. BSH2O is like $5/30ml and the vials are less than $1/each.

Good luck!
 
One more thing, would you be able to inject the new solution (with BSH2O) sub-q?
And how much can you inject sub-q, cause 1ml sounds like a lot for that.
 
You can do it sub-q, that's the only way I do HCG. I mixed mine a little stronger so I only had to do .3cc's per shot, 30units to get 500iu. I've done 1cc sub-q, it leaves a little lump that slowly dissappates over time, though it can get a little painful with that much sub-q.
 
Anakin said:
One more thing, would you be able to inject the new solution (with BSH2O) sub-q?
And how much can you inject sub-q, cause 1ml sounds like a lot for that.
You can cut the BSH2O in half so you will only need to inject 1/2cc. Less water could be used in the mix.....but it's so much easier IM.
 
jh23 said:
Try drawing up with a standard size syringe and pin and then pull the plunger completely out of the back of the insulin syringe and squirt the HCG in equal amounts into each insulin syringe. You of course will have to preload them, just make sure to store them in the fridge until you are ready to use them.

Is this sound advice, won't there be tons of air in the slin pin after you do that? I get the impression that you'll lose a lot of the liquid trying to get the air out of the syringe if you load it through the back end...
 
anakin, it is tricky the first couple times you try it, but it's the way I've always done it sucessfully. I just uncap the pin first, turn it sideways and barely put the end of the plunger in, turn it up so the needle points up and push out the excess air. Never had a problem, although help4john's method sounds like it would work very well, so I'll probably give that a shot next time.
 
It last 10 weeks with the solvent, no need for Bacteriostatic water. You are thinking hGH, bro. Ask a more experienced bro, like a mod, if you doubt me. Peace!
 
Youre right on the money bro. It makes absolutely no difference to the stuff whether you mix it with Bac water or the sodium chloride solution it comes with. The reason the manufacturers state that it is for immediate use is because once you snap the ampules open and mix it, it is exposed to air and essentially contaminated. Having said that since Bac water and multidose vials are so readily available i would do it that way.
 
help4john said:
Just a side note....are you planning on storing the HCG with the solvent mix in the frig? If so, it won't be any good after a couple of days anyways. If you are mixing with bacteriostatic water:

1) Draw 1cc of BSH2O into normal syringe (22,23, or 25 gauge)
2) Open HCG powder amp
3) Inject the 1cc of BSH2O into amp (mixing the powder and liquid)
4) Pull contents of amp into syringe (1cc, still 5000IU's)
5) Put the 1cc BSH2O and HCG combination into a sterile vial
6) Draw an additional 4cc of BSH2O into the syringe (or 2X at 2cc's)
7) Inject this into the vial
8) You now have 5cc in the vial
9) Inject 1/2cc ..... this will give you 500IU of HCG
10) Refrigerate for next use

Hope this helps! Good luck!

this is exactly what i have always done. always thought it was pretty much common sense to do it that way.
 
Top Bottom