Organon HCG

[jumpshot]

Repost from PCT Forum, it's dead.

I want to get opinions on using the 1mL solvent that comes with it VS getting vials and bac-water.

I read a post from a bro that just took the 1ml solvent, put that into the 5000 amp and drew out 5 slins pins to .2ml each = 1000iu's each.

Does this sounds right? And why wouldn't you want to use the solvent?

K to some info.

 

[cougar8]

Good question! Bump.

 

[buffalo]

Correct and i just use the solvent that comes with them,assuming your source supplies the solvent. I'm curious myself as to why not use the solvent that's supplied.

 

[jumpshot]

bump

 

[Bozwell]

Yes youre math is right,and you can mix it bac water because it will keep longer in bac water than solvent
solvent mix keep for 7 days
bac water mix keeps for 3 weeks
I think this is right

 

[black sheep]

Repost from PCT Forum, it's dead.

I want to get opinions on using the 1mL solvent that comes with it VS getting vials and bac-water.

I read a post from a bro that just took the 1ml solvent, put that into the 5000 amp and drew out 5 slins pins to .2ml each = 1000iu's each.

Does this sounds right? And why wouldn't you want to use the solvent?

K to some info.

When mixed with the solution the HCG needs to be used immediatly. When mixed with Bac. Water it will hold in the fridge for up to 60 days. If you are going to use all 5000 iu's in one shot, you can use the solution. If you are going to use it at say 1000 iu's EOD then you need to use bac water and put in the fridge.

 

[jumpshot]

ah, that sounds right to everybody?

7 day stability with the Organon provided solvent?

 

[jumpshot]

1 more bump

 

[Bozwell]

Ive kept mine the fridge for 10 days before and it worked the same, I wouldent go any longer though

 

[itlnstln]

Is it either or with the Bac water or solution - or do you still mix it with the solution it came with - then add the bac. water?

 

[Bozwell]

no mate, you use one or the other

 

[jumpshot]

I have limited experience with hcg, but here's what I did.

Used the solvent that came with. Drew the solvent with a 1" pin, slowly shot it into the powder amp. Swirled it around till it dissolved and then took 1/2" pins and drew equally.

Should have ended up with 5 shots of 1000iu each, but I screwed up a few. Any better way to get the hcg from the amp to the slinpin? It's a long tall amp and a short needle.

 

[Bozwell]

This is what I do if I can get slin pins(very rare),draw the mix out of the large powder amp with youre normal set up then put it back into the small solvent amp ,then use slin pin