needle sizes?

[hostile_tjd]

Im going to start a cutting cycle in the near future, so im preparing now. I will be doing test prop and tren with oral winn. I was told to use 25 gauge needles to pinn and 20 gauge to draw. Im not sure how to use two needles, do I just take the 20 gauge of and put a 25g on the syringe, or can I use a 25g to draw and pin, even though im sure it will take forever to draw? 5'8 220 12% bf and right now im on a bulking cycle so I know how to draw and pin, but im just using one 23gauge 1 1/2 needle to draw and pin and thats working fine. thanks

 

[stevesmi]

always switch out needles.. it might become less sharp while you are drawing.

 

[goal245]

its going to take a while to draw with a 25g not to mention that after you draw with it from 2 vials it will be dull and will hurt when you stick your muscle.

 

[dr.shavargo]

deffinatly just buy a syringe and needle with a 18-20g needle to draw and then buy seperate 25g to swap on to inject with.

 

[hesnobradpitt]

When you order you pins order needle and syringe 3ml with 20 gauge pin , then order just pins at 25 gauge and after draw then change to the extra pins .


Brad.

 

[KenBraggofCarroltonGA]

change your pin and you'll be amazed how easier it goes in. are pinning eod? aspirating? and do u have a pct planned out?

 

[hostile_tjd]

yep pinning every other day and pct is clomid and nov

 

[ALIN]

Im going to start a cutting cycle in the near future, so im preparing now. I will be doing test prop and tren with oral winn. I was told to use 25 gauge needles to pinn and 20 gauge to draw. Im not sure how to use two needles, do I just take the 20 gauge of and put a 25g on the syringe, or can I use a 25g to draw and pin, even though im sure it will take forever to draw? 5'8 220 12% bf and right now im on a bulking cycle so I know how to draw and pin, but im just using one 23gauge 1 1/2 needle to draw and pin and thats working fine. thanks

The pins screw on the syringe (most anyway)
When your getting ready to draw, screw the 20g on withdrawl
the needed amount. When you ready inject,,remove the 20g
and use a 23-25 gauge pin to inject.