Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

My tren HURTS

sauerbrauten

New member
Its geting to the point where i think i have to stop cycle..i have no more injection spots to shoot... my as has been sore for 8 days cant sitt. delts are faling off.. legs are paralized..i can tput on socks..this shit hurts...anyone else tried this premade mix...40 cc vial Hint hint ( Freak of nature ) Bolin :)
 
Sounds like the BA is too high. I just had the same problem with IP tren. It was my first tren cycle and I was alternating between IP tren and TTykko. The IP shots were a misery... too much BA.
 
hmmm.

Tren should NOT hurt at all. As a matter of fact, if you are using 25g or thinner you shouldnt even feel it going in. I did tricep injects and felt nothing.

Cut the BA down a little, if you are worried about infections, pastuerize at 170 degrees for 15-30 mins a few times and it will kill most bacteria.
 
Tren always gives me pain. Lats cycle I used homebrew tren and it absolutely killed me (A's kit). This time around I'm using Spectro OmegaTren and it leaves the muscle a little sore the next day or two.
 
I felt the same way first time I made homebrew. I could barely get in and out of my car, much less do a leg workout. Somehow I got threw it though. I would keep going until it is absolutely unbearable.
 
Polfa/Jelfa said:
Its geting to the point where i think i have to stop cycle..i have no more injection spots to shoot... my as has been sore for 8 days cant sitt. delts are faling off.. legs are paralized..i can tput on socks..this shit hurts...anyone else tried this premade mix...40 cc vial Hint hint ( Freak of nature ) Bolin :)

if its due to high BA content, you can easily solve that problem, try this:

1) mark the level of oil in the vial
2) stick a 23guage needle in the vial (to let the vapor out)
3) put the vial in the oven
4) heat it up to 220F
5) keep evaporating BA untill the oil level in the vial stops droping
6) add steril oil back up to the marked level of the vial
7) heat back up and mix

ALL DONE, painless vial of tren ready for use
 
Top Bottom