Multi Compound Injections

[madmatt]

When using a mutidose vial I have heard to inject an equal amount of air into the vial before drawling the fluid. How in the hell can you take say one ml. of Deca and turn around and take another of Test.? If you have fluid in the syringe then you can't put air into the 2nd vial. I am guessing that you have to mix the two compounds in something else first, before filling up the syringe. I am planning on running Test. Prop. and Deca. I know that the Deca may make the Prop. eaiser and less painful to take. Therefore, the correct method for taking multiple compounds must be explained to me. THANKS EVERYONE!

 

[madmatt]

SORRY GUYS ABOUT THE MULTI POST

I DIDN'T THINK MY MESSAGE WAS GOING IN AND HIT THE BUTTON A FEW TOO MANY TIMES! PEACE!

 

[Canuck4]

Good job

 

[nautica]

hold it upside down and the air will be at the top and the fluid at the bottom.

But it is really not that neccesary to put air into the vial so long as you can draw the fluid out.

nautica

 

[alien amp pharm]

Yeah - what Nautica said......
I have never pushed air into a vial and never had any problem getting the juice. And yes holding it upside down is proper procedure.

 

[gsxr]

Say you were going to draw 1cc of deca and 1cc of test, then you would draw 3cc of air and inject 1.5cc of air into each of them. Then you can insert the needle into each pressurized vial, flip over the vial and easily be able to easily draw 1cc of juice out of each. Hope that helps.

 

[acneman]

once youve drawn the decca 1ml draw 2ccs of air in the syringe this clears the needle then turn the vial over and push the syringe in from the bottom then push in 1 cc of air. this leaves 1cc of air still in the syringe

draw out one cc of tes measure from the 3ccmark to the 2 cc mark pull out the syringe and tap it then push out the air till one drop forms on the end of the needle carefully draw it back till the drop disappears then inject