Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

Melanotan II

mish12345

New member
hope this is ok in this forum, just got my MT2 today, its not mixed yet as I wont be using it for about 2 months, will it be ok left in crystal form in the vial at room temperature? or should I put everything in the freezer?

thanks for any help :artist:

also its GEP (Genetic Enhancement Pharmaceuticals) anyone used this?
 
put the un-used vitals in the freezer and mixed vitals in the fridge .. no never herd of the company personally
 
none of it is mixed, i just have 2 MT2 vials and 1 bottle of b/c water

the MT is in crystal form so just put it all in the freezer?
 
^^^yes put it in the freezer or it will go bad alot quicker.. dont remember the exact timeframe .. mt II is fine to put in the frezzer .. ive dont this .. after u mix it with the bac water then put it in the fridge ..room temp either way is not good .. will go bad quicker either way
 
noo it will be good longer then that .. not sure off the top of my head .. would guess around a years time frozen ..
 
i have been on MTII for over two years now, absolutely a miracle drug for fair skinned people. but i hate to tell ya if you have only 2, 10mg vials that isnt even enough for a loading phase. 30mgs is what needs to be taken for a loading phase and then the maintenance phase can start. i know probably 20-30 people that use the drug and i have never heard of that company. be careful, there are alot of fakes out there. oh ya, keep unmixed in freezer and mixed in fridge. also be carful mixing it, it is very volitile and can be damaged easily. let the ba water flow down the side of vial and then roll it slowly on table top to completely mix it.
 
I've done quite a bit of research and everywhere I've read says 20mg is definately enough. I'm not going to be doing 1mg a day like a lot seem to, will only start on 0.25mg.

the product looks UG Lab are most the companies that do MT2 underground?
 
mish12345 said:
I've done quite a bit of research and everywhere I've read says 20mg is definately enough. I'm not going to be doing 1mg a day like a lot seem to, will only start on 0.25mg.

the product looks UG Lab are most the companies that do MT2 underground?
i think you should do some more research bro. if you only plan on doing 20mgs total you are really wasting your money. at 200lbs you need to ramp up to about about 1.8 mgs every day for your loading phase. then you need to take 1.8mgs twice a week for your maintenance dose. the loading phase can take anywhere from 20-30mgs total depending on your skin type. i have no idea what your stats are though.
 
Found this online.............read it if you want to use this stuff.

OK all, this has been a long time coming but I finally got around to it. Instead of a chart, this time I think I'll just provide a formula to calculate dosage per injection and some guidelines to follow. The formula and guidelines are meant for the broad population of experimenters and will most likely be a good fit for 85% of you. So without further adieu ...

First, the non-metric version:

A = total mg of melanotan II in vial
B = your weight in lbs
C = (0.0025 * B) = mg per injection
D = A / C = total injections
E = D * 0.3-0.5 = amount of diluant to add to vial

For metric users, apply the kg to lbs conversion ...
B = 2.205 * your weight in kg

Once you know the number of "total injections" that can be obtained from the given amount of peptide in the vial ... you will then be able to fill the vial with diluant based on that number. You do that by multiplying the total injections by the amount of diluant you wish to use per injection. My preference is anywhere from 0.3cc to 0.5cc or 30-50 mark on your syringe.

Here's an example ...

A = 10mg in vial
B = 200 lbs
C = 0.0025 * 200 = 0.5mg per injection
D = 10mg / 0.5mg = 20 injections
E = 20 * 0.3cc = 6cc diluant

Therefore, 6cc of diluant must be added to the vial containing 10mg of peptide. One should then draw up 0.3cc (or to the 30 mark of the syringe) per each injection ... totaling 20 injections at the recommended concentration of peptide.

If one becomes adjusted to this concentration AND does not experience side-effects AND wishes to increase the consumption rate, I would recommend doing 2-3 injects per day spaced out over even intervals of time. The less preferable route would be to draw up more solution into the syringe per injection, but you would do this at an increased risk for side-effects. It has been proven in dosage trials by Clinuvel that using less peptide delivered in a slow-release fashion is significantly more effective at increasing melanin than if delivered in greater amounts all at once.

For most first-time Type-I/II users, you will likely need to get through at least 30-40mg. As you can see from the formula, this may take some time to complete. You may wish to up the concentration by drawing up more solution per inject, but only if you experience no sides. Once you have completed your first cycle you will be on maintanence dosing. At that point, the above formula should be the way to go. I'd say 10mg per 4-6 weeks for maintenance.
 
I have done heaps of research, another forum I use suggests a lot less than this to be used. also I dont want to risk going too brown.

Thanks for the formula, just one problem - the vials I have are so tiny that I can only fit 1ml water in them. Each vial holds 10mg. So is this a problem? Does it mean sides will be more likely and the product wont be as effective since I am starting on 0.25mg/day? Meaning I will be drawing up a miniscule amount of liquid, but it will be very concentrated.
 
timber1976 said:
i think you should do some more research bro. if you only plan on doing 20mgs total you are really wasting your money. at 200lbs you need to ramp up to about about 1.8 mgs every day for your loading phase. then you need to take 1.8mgs twice a week for your maintenance dose. the loading phase can take anywhere from 20-30mgs total depending on your skin type. i have no idea what your stats are though.

At 200lbs I did 1mg/3xper week for 3 weeks and got dark as shit, then kept it up and people thought I was spending all my time at the beach. LOL
 
yeah I thought that was all you need. certainly wont be getting to 1.8mg a day, I've heard of moles and skin problems coming on at doses even lower than that.

how often did you use sunbed goinon4t?
 
goin on 4T said:
At 200lbs I did 1mg/3xper week for 3 weeks and got dark as shit, then kept it up and people thought I was spending all my time at the beach. LOL
that is about the same amount i am doing, only i am doing it twice a week instead of 3 times a week for maintenance.
 
does any one know if doing reserch with ag melanotan 11 if their product is already mixed or is it the powder like above ?
 
try to take it at night before you go to bed. I gave 10mg to a buddy and didn't tell him that. He said he was sick to his stomach. I felt bad for the guy. Then he darkened up like a mofo. BTW I haven't take any in months and I am still dark!
 
sdever said:
does any one know if doing reserch with ag melanotan 11 if their product is already mixed or is it the powder like above ?
it all comes in solid form. my manufacturer said it is only good for a few weeks after mixed. and once mixed it needs to be refidgerated. also it is a good idea to take it before bed because it gives u raging hard-ons to, the drug is also used for ED.
 
I dont' mind sounding stupid. whats the diff between 1 and 2?
 
cboogsrun said:
I dont' mind sounding stupid. whats the diff between 1 and 2?

I think version 2 works better, but at the same time I have also heard that a full dose can make a man hard like the oak tree...so to speak. I'd have to research more on this one because I've never used it but I have thought about it.
 
Top Bottom