is this ok to do?

[lifthard2005]

bros - is it ok to heat up a coffee mug with hot wat and to submerge the full syringe in using an 18g that i filled my syringe with and let it sit in the hot water to heat up the casing/oil? then remove it, attach my 23g pin for injection to make for smoother injections?

 

[cadey]

just run the barrel under the hot tap for a minute the change the pin. works for me

 

[gettnlarge01]

I microwave some water in a cup then put the whole vial in the cup for 5minutes before drawing out what I need.

 

[Kick-Ass Stack]

I microwave some water in a cup then put the whole vial in the cup for 5minutes before drawing out what I need.

I would imagine that putting the vial in a cup of warm water would probably be ideal. I don't think you would want the stopper submerged. I think this would be preferable to pouring running water over it just to keep it more sterile.

What kinda gear are you trying to losen up?

 

[gettnlarge01]

I would imagine that putting the vial in a cup of warm water would probably be ideal. I don't think you would want the stopper submerged. I think this would be preferable to pouring running water over it just to keep it more sterile.

What kinda gear are you trying to losen up?

My bad.I just submerge about 3/4 of the vial in the cup. I'm injecting ed so I heat up the gear just to use the smallest pin I can to avoid too much scar tissue build-up.

 

[jagerbombme]

My bad.I just submerge about 3/4 of the vial in the cup. I'm injecting ed so I heat up the gear just to use the smallest pin I can to avoid too much scar tissue build-up.

what size you use? i use 25

 

[20ss02]

If you want something quick and easy - use a lightbulb. I draw my gear into the syringe, then I place it next to a lightbulb in my bathroom.

 

[missionpossible]

Or you can put the vial on the in-line transformer located on your power cord for your computer or printer. This gets warm enough to work great for oil based products through a 25g.