Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

Is this gonna be a problem

The_Ghost

High End Bro
Platinum
Got my oil based Test yesterday but it was so cold outside both the Prop and Enan was frozen solid.

Will this stuff still be ok, does the freezing then unthawing change anything?
 
gilly6993 said:
I would put it on the stove top at a very low heat....the metal in the cap on the vials could cause a problem......

it unthawed already, are you saying I should still do this and if so, for what reason?

Thanks
 
Bigdawg1468 said:


it unthawed already, are you saying I should still do this and if so, for what reason?

Thanks
Because most people are assuming that since your gear was frozen that your test crystallized. You see—this is actually one of the simplest “checks” that you can perform to check if there is any hormone in your oil. “The freezer test.”
 
I'm sure the microwave is fine, I just prefer the stove because I dont like the idea of microwave radiation going through my gear, who knows what could change.
 
benevolent anarchist said:
Because most people are assuming that since your gear was frozen that your test crystallized. You see—this is actually one of the simplest “checks” that you can perform to check if there is any hormone in your oil. “The freezer test.”

After it thawed it looks perfectly fine although I didn't look that closely.
 
keeponriding said:
I'm sure the microwave is fine, I just prefer the stove because I dont like the idea of microwave radiation going through my gear, who knows what could change.

The radiation could alter it into a Mutating GamaRay hormone that can turn you into a green skined Lou Ferigno :)

Seriously... boild some water... take it OFF the stove, put the vial in it, let it sit for about 10 minutes.
 
Big Rick Rock said:


The radiation could alter it into a Mutating GamaRay hormone that can turn you into a green skined Lou Ferigno :)

Seriously... boild some water... take it OFF the stove, put the vial in it, let it sit for about 10 minutes.

Perfect I will start putting all my gear in the microave ;)

Thanks for all the input!
 
Top Bottom