Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

insuline pins????

MR Pink

New member
Today I bought some insuline pins for my hcg and b-12 shots....but the needles are fixed to the syringe! how do you guys draw the hcg and b-12 out of the amp with a insuline needle?
 
MR Pink said:
Today I bought some insuline pins for my hcg and b-12 shots....but the needles are fixed to the syringe! how do you guys draw the hcg and b-12 out of the amp with a insuline needle?

i dont tip:D
 
just kiddin bro i'll bump this for ya as i have never used insulin pins

try drawing the b12 up with it. b12 is really thin. let me know if it works
 
Let me see, if your trying to get it out of an amp just break the top of the amp off. I do it where it breaks more on one side than the other. Then I simple lean the amp to the side that is broken the most. Insert the needle and place it on the glass ( the now bottom part of the amp since it's now leaning on one side). Draw the liquid out slowly until I can't get anymore liquid. Then as I hold the amp in my left hand and the needle in my right I start to lean the amp over more so that it causes the liquid to run down the glass as if I were going to poor it out. At the same time I'm trying to draw and get as much as possible.

I hope you can understand this. I usely get most of it out, maybe there's only a bubble or two of s*** still in there.
 
MR Pink said:
Today I bought some insuline pins for my hcg and b-12 shots....but the needles are fixed to the syringe! how do you guys draw the hcg and b-12 out of the amp with a insuline needle?

Same as you draw w/any other amp - only if you using a slin needle then your must be patient. It will take a few minutes.

Good Luck!
 
Yeah I get it I thought it was done the way speedfreak5 said but I was hoping for a unknown method:D.

Now another question...I will be shooting several small dosages hcg each week....I have 2500 iu amps so that means it takes about 10 shots to empty the 2500 iu's......since the 2500 iu's are in the syringe I have to use the needle more than once since I can't change the needle...how the fuck do you guys do this? or should I just stick to a 24 g needle and avoid all this trouble?
 
MR Pink said:
Yeah I get it I thought it was done the way speedfreak5 said but I was hoping for a unknown method:D.

Now another question...I will be shooting several small dosages hcg each week....I have 2500 iu amps so that means it takes about 10 shots to empty the 2500 iu's......since the 2500 iu's are in the syringe I have to use the needle more than once since I can't change the needle...how the fuck do you guys do this? or should I just stick to a 24 g needle and avoid all this trouble?

Mix your HCG then put it into a multi-dose vial
 
I've got it I'm gonna use a 5 ml syringe as a multidose vial....I'm gonna draw the solution from the syringe opening and seal it of with a needle
 
The Terminator said:
I would draw the 2500 IU up into 5 separate slin pins (thus giving you 500 IU in each one...(theoretically anyway...)

I beleave this would be a little harder, to split the dose. I use 5000 iu amps, and I find it hard to split that more then once into two different needles. There just isn't enough liquid.
 
SpeedFreak5 said:


I beleave this would be a little harder, to split the dose. I use 5000 iu amps, and I find it hard to split that more then once into two different needles. There just isn't enough liquid.

You could order some bacteriostatic water from GPZ for $5 per 30 ml. vial :)
 
Amps are special in that once the top has been popped off, you can turn it upside-down and the solution will not come out. So w/ the amp turned upside-down, you can draw out all the liquid w/ a slin pin.

I'm using 5000iu Pregnyl HCG. That means 5000iu in approximately 1ml of liquid. So I mix the liquid and the powder. I draw it all up and squirt it into a sealed vial (from getpinz). I like doing my HCG @ 500iu ED for a few days. So w/ these numbers, all I have to do is draw 1/10th of a ml (draw up to the 10 line on the slin-pin) which is the equivalent to 500iu of HCG. Then I just stick the vial in the fridge till the next day.
 
why dont u just draw with a reg pin and pull the plunger out of the slin and then fill ur slin resivour then put the pulnger back in....insert plunger with teh needle up so u dont push all of ur gear out tho. thats how I do it.
 
Top Bottom