Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

Injections

Dedication777

New member
Okay so when you guys inject, I know there Is plenty of ways to do this, but I'm curious how you guys do it?
Do you leave a air bubble in the syringe to insure all the oil comes out?
When you inject how do you prevent oil leaking from the hole, this happens to me quite often.
I leave the syringe in my leg for 30 seconds then take it out a put pressure on it for 30 seconds.
 
Leave a little air bubble. Flip syringe empty the air from tip. Inject and aspirate. When oil is fully injected remove half of needle and wait then remove it all. This will prevent oil from common out.
 
Okay so when you guys inject, I know there Is plenty of ways to do this, but I'm curious how you guys do it?
Do you leave a air bubble in the syringe to insure all the oil comes out?
When you inject how do you prevent oil leaking from the hole, this happens to me quite often.
I leave the syringe in my leg for 30 seconds then take it out a put pressure on it for 30 seconds.

I do leave a small bubble to expel the whole contents of the syringe. I also inject slowly.
 
I do the same as alin leave a tiny air bubble and inject slowly no need to waste time aspirating.
 
Radar can u please explain why aspirating would be a waste of time?
Thx



I've done thousands of pins and never had a problem, sure you may go thru a vein but thats no biggie, Docs do it to but they cover it up with a cotton swab so you don't notice.

Besides aspirating is going into the muscle along with the air bubble ,this will be slowly asorbed by the body because you injected into muscle tissue.
 
Last edited:
I never aspirate, I leave usually about 1/2 cc air bubble in to make sure all is absorbed

Sent from my SGH-T989 using EliteFitness
 
I also never aspirate and leave an air bubble, and have never seen a medical professional aspirate either.

NTBM REP
 
1/2 off a cc air bubble?? damn.. is that the case with all of y'all.. or are the rest of you saying you just leave a little air bubble at the bottom? I've always heard to never leave an air bubble
 
1/2 off a cc air bubble?? damn.. is that the case with all of y'all.. or are the rest of you saying you just leave a little air bubble at the bottom? I've always heard to never leave an air bubble

I probably leave close to a 1/2 of air to make sure all the juice gets pushed out. The air bubble has never hurt me and I dont waste any juice.

NTBM REP
 
Top Bottom