Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

Injection Question.........

  • Thread starter Thread starter JC Grifter
  • Start date Start date
J

JC Grifter

Guest
I am going to inject into my shoulder. I have 1.5 inch needles. I am pretty sure that is too big, so I was wondering if I could still use them, but not stick all the way in?
 
JC Grifter said:
I am going to inject into my shoulder. I have 1.5 inch needles. I am pretty sure that is too big, so I was wondering if I could still use them, but not stick all the way in?
YOU ARE RIGHT, GO ABOUT 1 INCH IN OR A LITTLE LESS BUT YOUR RIGHT.
 
You can do it, but it's not advisable since the needle can move a lot more if it's not buried all the way in, which can make it more likely to hit a vein.
 
It will work. I am using 23g 1.5inch in my delts but I would rather have an inch so it doesnt have the chance to move. So if you havent gotten them yet go with the 1 inchers. If you have them already then you will be fine, just keep your hand steady. Good luck

Chuck
 
I also site injected my delts with 1.5" 23 gauge with no problem but I angled the needle slightly rather than going in at 90 degrees and BTW it was with Primo and the results were excellent!
 
I know plenty of guys who have used the full 1.5's for injections with no problems.These guys were also fairly large and had plenty of meat to hit.
 
Just cut one of the needle sheilds to cover 1-1/8" of the needle. Store it in alcohol to keep it clean. Now you will only be able to stick 5/8" in, no need to worry about holding perfectly still.
 
damn, that is an awsome idea, cutting the shield... thanx for the tip bro:D
 
nothing but the ole buttock for me....

thought about a thigh injection.....but i look down and see all those viens....and I change my mind everytime......
 
I tried my leg today, and it hurt like hell.... i am sticking to glutes and gona start shoulders
 
Top Bottom