How to not waste product when pinning?

[8800gtx]

I hate wasting anything. Especially expensive Hgh. My hgh is 1 iu per 0.1 cc. When I draw up the hgh into the syringe I put exactly 0.4ccs. After injecting all the liquid, I have about 0.05ccs left in the syringe that doesn't get injected because its stays between the plunger and the needle. What exactly do you guys recommend so that I avoid this waste. I've been reusing my syringes (not needles) to save this extra for the next time I shoot.
I'd love to hear feedback.

 

[ALIN]

I hate wasting anything. Especially expensive Hgh. My hgh is 1 iu per 0.1 cc. When I draw up the hgh into the syringe I put exactly 0.4ccs. After injecting all the liquid, I have about 0.05ccs left in the syringe that doesn't get injected because its stays between the plunger and the needle. What exactly do you guys recommend so that I avoid this waste. I've been reusing my syringes (not needles) to save this extra for the next time I shoot.
I'd love to hear feedback.

I leave a small amount of an air (a bubble) and it helps clear the syringe on the final end of the push.

 

[8800gtx]

Is this not dangerous? I've always been over cautious because of all the stories I've heard myths or not about air bubbles in the blood stream causing aneurysms. I generally pin directly intramuscularly. And sometimes subq if I'm lazy.

 

[FunKoMaN]

I'm pretty sure what you're thinking of is if you inject air directly into a vein. A tiny bubble subq or IM probably won't affect you in any way.

 

[hurricane]

Is this not dangerous? I've always been over cautious because of all the stories I've heard myths or not about air bubbles in the blood stream causing aneurysms. I generally pin directly intramuscularly. And sometimes subq if I'm lazy.

a tiny air bubble into a muscle or fat isnt going to hurt you

 

[RickRock13]

A little bit of air behind the plunger will push all of the oil out, and that very small amount will not hurt you in any way

 

[bobsyouruncle]

Terumo slin pins are the best option for not wasting gear and like others have said leave a little air in there I always do this and it's nothing to worry about it will find it's way back out and it gives you a nice audible when you're done injecting (the sound of the air bring pushed through) the only thing to keep in mind is the angle of the pin you want the plunger slightly higher than the needle with something as thin as hgh the air will travel to the highest point this is not as crucial with thicker oils


Sent from my iPhone using Tapatalk