Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply puritysourcelabs US-PHARMACIES
UGL OZ Raptor Labs UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAKUS-PHARMACIESRaptor Labs

Homebrewed Tren...how much per ml do I have?

st8grad

New member
First off this is exactly why people like me should not be homebrewing Tren.

Although the method I used was great. I was as sterile as I could be with everything in site disinfected with bleach beforehand, etc. But still I think this should be left to more capable (and intelligent) people than me.

I bought the conversion kit from GPZ. First I removed 5cc of oil from the big bottle.

After brewing I had a solution minus the gunk and small loss of oil that was 17cc.

I flitered it all plus the 5cc of oil for a total of 22ml. This of course was a 2gram kit for the 2g cart.

In a perfect world with 20cc and no loss I would have 100mg/ml right?

So can anyone shed some light on what I have now? Also factoring in the typical amount that is lost in coversion. Plus another couple percent that didn't make it into my magic solution.

Thanks for the help in advance bros!
 
a 2g cart of finaplix contains 2000mg trenbolone assuming a 100% extraction/conversion.

2000mg/17cc = 117.65 mg/ml
2000mg/22cc = 90.9 mg/ml

I can not tell you how much you lost in conversion, because I did not observe it. 90.9 mg/ml would be the HIGHEST possible amount, with your probably under that. I would call it 80mg/ml and dose accordingly. Might be a little over/under but most UGL are also.
 
Thanks s8n. I don't think I want to run 80mg or above ED for my first go around. But I think 40mg is a little light too. Thanks again.

s8nlilhlpr2 said:
a 2g cart of finaplix contains 2000mg trenbolone assuming a 100% extraction/conversion.

2000mg/17cc = 117.65 mg/ml
2000mg/22cc = 90.9 mg/ml

I can not tell you how much you lost in conversion, because I did not observe it. 90.9 mg/ml would be the HIGHEST possible amount, with your probably under that. I would call it 80mg/ml and dose accordingly. Might be a little over/under but most UGL are also.
 
st8grad said:
Thanks s8n. I don't think I want to run 80mg or above ED for my first go around. But I think 40mg is a little light too. Thanks again.
Then go with 3/4cc's ED. That would give you about 60mg (depending on the efficiency of your conversion).
 
Top Bottom