Homebrew Test E problem

[Fajitas]

I'm starting my first Test E powder conversion. I have 25 grams of Test E powder and when I first received it, it was in powder form. Now that I am ready to use it I have found that it has degraded into a sticky yellow, waxy, mollases type consitency. The problem I am having is getting all of it out of the plastic baggie that it came in. I've tried refrigerating it but that only makes it worse. Should I try heating the plastic baggie and will doing so hurt my product?
I have a feeling that I am going to lose at least a 1/3 of my product because I cant get it out of the plastic bag.

I'm sure someone has run into this problem before, any ideas?

 

[Fajitas]

^^^

 

[maxpain]

Dude you are in the wrong forum for this. Post in the bodybuilding chemistry forum. More folks there to help you.

 

[Advisor_x]

Tren shoulb be refrigerated.........

 

[linux]

You have a couple options here......Id start by putting it in some hot water...only as hot as your tap water goes. That should melt it all down into a nice liquid. then cut the corner of the bag and pour it all out. you can use something flat to squeeze most of it all out. Or after you melt it all put it in the freezer and the whole thing should freeze into a solid block. Then you can open the bag and take the whole block out at once. Your gear is fine.

 

[fcfmuaythai]

I agree with linux. I would personally put it in a hot water bath (keep the powder in the bag). The powder will then melt and cut the corner of the bag and squeeze it all out, you should be able to get almost all of it out. Good luck.

 

[Fajitas]

Sounds good guy's thanks for all the help!