Please Scroll Down to See Forums Below 
mrflexdiesel
New member
Just got my ********* liquifen earlier today and it looked as if it had been sitting for awhile. Had a bunch of white residue stuck to the bottom of the vial that would not come off even after shaking vial for awhile. I read you could heat it up to loosen up particles and help the suspension dissolve better, which is what I did. I just wanted to make sure that I havn't damaged the product by possibly overheating it. The sink water wouldn't get hot enough to allow the residue to break off from the vial so I actually heated a coffee mug of water up for about 30 seconds in the microwave and then dipped the vial in near boiling water for a little bit while swirling. After a couple of goes the residue released and everything seemed to blend together better. Just wanted to make sure I didn't cause any damage to it by heating it up to about the boiling point of water?
Last edited:
