Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

Heat the oil

SinisterUproar

New member
cannot believe how much this helps. I always use a 25g pin and I just started heating the oil before injection and it has been so smooth. Love it!
 
Nice one will have to give it a shot how you go about doing it ?? In put vial in dish with warm water ?
 
Put a tea towel under hot water. Ring the excess water out and place the vial in centre. Leave for 5 mins and you are gtg. Works like a charm :)

Sent from my GT-I9305T using EliteFitness
 
Coffee cup of water in the mic for 2 mins. Place vial in for a couple mins.

Sent from my Galaxy Nexus using EliteFitness
 
I saved our baby bottle warmer... i put in a few table spoons of water and the steam heats it in seconds... thing is a life saver

Sent from my Z10 using Tapatalk 2
 
Yeah i've done the hair dryer or putting the vial on the stove on low-med heat for a few minutes. It does help, but i prefer just to make my gear thinner so it flows through easier.
 
Top Bottom