first glute pin..lower back swollen?wtf

[solidrock5]

gotta a question for a buddie of mine, so he did his first glute injection and the gear it good because ive tried it no prob but he pinned the top outter part of his glute, aspirated and went in fine, and his lower back is now painfull and swollen is it just his body getting used to the gear...he has pinned quads and they were sore but not as sore as this.....anyone have any info??

 

[underattack]

I got this last pin actually hurt like hell and i sas unable to sit for 2 days. And my back couldent touch anything.
Imo ita a to short needle.

 

[kc17]

gotta a question for a buddie of mine, so he did his first glute injection and the gear it good because ive tried it no prob but he pinned the top outter part of his glute, aspirated and went in fine, and his lower back is now painfull and swollen is it just his body getting used to the gear...he has pinned quads and they were sore but not as sore as this.....anyone have any info??

it happend to me a few times too last week , I'm inclining to believe it the quality of the gear or how its getting brew . Take some motrin and apply hot towel a few times a day,also check out spotinjections.com and make sure you hit the correct spot and inject slow.

 

[solidrock5]

yea.....it could be the length of pin...he said he didnt stick the 1 1-2 all the way in.....yea his tail bone is killin he said..

 

[solidrock5]

would it be a waste of gear if it wasnt in all the way or would it take longer or quicker to move through the system?

 

[solidrock5]

come on....now body else?

 

[moya]

its not a waste of gear... some say it will change the rate of release but imo the difference is probably a negligible amount... im sure the ester help keeps the release steady at least...

he may have a depot near a nerve putting some pressure on it...
could be a sterile abcess, this can happen when your body experiences something foreign to it and tries to attack it even though its not harmfull... your body just dosnt realize it yet...
could be the solvent content in the gear...
lots of things it could be, but its best to keep an eye on and if the condition worsens after the first couple days then its probably something to worry about...
my bet is that the injection was not deep enough and that usually causes a deal of discomfort...