Fina question, Please help!!!!!

[bigman1]

I just finished making my Fina and did my first injection. Well it does not hurt going in but about 1 hour later a little bump( like the oil is just sitting there) hurts like hell, What causes this and will it still work. I have had this happen before with some Omandrens(sp?). Has anyone had this happen let me know what I can do. Thanks

 

[Zyglamail]

Who's kit did ya use and did you alter the concentration at all?

 

[bigkraut]

It happens to me, too. Don't sweat it. It's normal.

 

[bigman1]

I used Finakit.com and I did it just as it said and I lost some during the filtering phase due to pushing to hard and it breaking through the sryinge plunger first time mistake I know now not to push to hard.

 

[Zyglamail]

If you bump the concentration up it will make it sore and some kits are generally more painfull than others. I occasionally get small knots when I do glute shots because I didnt get deep enough and some of the fluid pooled between muscle and the skin. Soesnt usually happen in the quads but it has on occassion.

 

[bigman1]

I'm not sure on how you bump the concentration up. Can you help me here I'm new to making this and I know it will be easier the next time. Question though will it still work or does it have to break down first or is it just the oil that is sitting?

 

[Zyglamail]

Your stuff sounds fine, just make sure your deep in the muscle. As for making it a higher concentration (ie 150mg/ml) you with hold some of the oil during the conversion, how much will depend on how strong you want to make it. I for one wouldnt recommend it, just leave it at 75mg/ml.

 

[bigman1]

Thanks bro for the help.

 

[chickmagnet]

bigman...
i had this same problem with fina a few months ago...it hurt like HELL! After the fina is in the syringe, run it under really hot water for a minute or two, inject it slowly, then rub it into the muscle. Took almost all of the injection pain away. hope this helps.

 

[bigman1]

Thanks chickmagnet, I will try that next shot. I hope it works