Please Scroll Down to See Forums Below i read and searched the posts for the procedure to make the injectable. i think that i did it wrong though. i found a file on the internet that said to crush the fina tabs and add them to 45 ml sunflower. i did this on the stove at 195 degrees in a water bath and shook occasionally for about an hour, then i filtered through two coffee filters. the coffee filters had some brown gummy sand in the bottom. is this safe? the article said that i would get out the fillers and some of the binders. did i ruin the mixture, it is clear and i did bake it 3 times for 15 minutes in the sterile 10ml vial to sterilize it. is all of the tren in it, are the binders still present and if so what will be the effect on my body?
fina mixture
- Thread starter foe516
- Start date
A
Adaptek
Guest
dood, shoot that shit up. Let us know what happens 
just kidding man, wait for some proper advice from a guru.
just kidding man, wait for some proper advice from a guru.
Fina pellets have a lot of binders/glues in them. That is likely what got trapped in the coffee filters. Weather or not any tren was left is hard to say for sure. Personally I use the one and only A kit which comes with a "magic solution" to help break down and seperate the glues/binders. The heating should melt the tren which if I am not mistaken has a very low melting point (something like 186f) which chould allow the trem to be suspended in the oil and pass through the coffee filter. A kit is really not that expensive and I think your final product is probably better when using one and you dont have to deal with the messy hassle of coffee filters.
hard
New member
hey bro,
substitute pure acetone for sunflower oil in the 1 st part, pour thru 2 coffee filters then let it evaporate somewhere safe( i.e. where do you keep the gas for your mower ) with a coffee filter on top to keep out floaters THEN add enough sunflower oil (preheated to 250) to make a concentration of 75mg/ml and voila. .
Once you have your mix into vial(s) : heat the vials at 250 for 15min/ let cool for 15 min ...repeat 2 more times.
Store in a cool dark place.
NOTE: Do a search on Fina on the board for more complete info as well as I am just a chemhacker.
good luck
substitute pure acetone for sunflower oil in the 1 st part, pour thru 2 coffee filters then let it evaporate somewhere safe( i.e. where do you keep the gas for your mower ) with a coffee filter on top to keep out floaters THEN add enough sunflower oil (preheated to 250) to make a concentration of 75mg/ml and voila. .
Once you have your mix into vial(s) : heat the vials at 250 for 15min/ let cool for 15 min ...repeat 2 more times.
Store in a cool dark place.
NOTE: Do a search on Fina on the board for more complete info as well as I am just a chemhacker.
good luck
i don't think you need the magic solution after readin this:
www.elitefitness.com/members/finaplix/reports.html
www.elitefitness.com/members/finaplix/reports.html
You dont "need" magic solution or a kit, its personaly choice. However, you saw the gunk(mc?) left behind after crushing and filtering. I have only used a kit, but some say when they have the gunk in the final product injections burn. Aside from that they appear harmless. I personally think the kits a bit easier, no coffee filters, no grinding pills etc.
