Drawing it up

[biggguns]

Man I had a hell of a time drawing the deca up. First I opened a Sust amp and got that up and injected that into the deca vial. Then, (Organon deca, w/ a 22 gauge needle), I would inject air (about 2cc's) into the deca vial and then try to draw it back out, it was like the plunger was being pushed back from the air pressure and nothing was coming into the needle. I put the deca vial into some hot water and it drew up, but something is not right here. Any help in this area. I have to be doing something wrong.

 

[Spunky]

are u holding the vial upside down? if u heat it up and are drawing w/ a 22g i don't think u should have any probs. call me crazy but i heat everything and draw it with a 25g, the same thing I use to inject it with. sometimes it goes a little slow but i've never had any problems, except with injectable anadrol it took a while... try a 18g for drawing and then switch the pin back to a 22g. good luck man

 

[biggguns]

This was my first time, so I think I was not holding it upside down. Finally I did and it came out slowly but good. Is there a better way with the amps, because it seems to be kinda difficult since you can hold them upside down?