Drawing from a vial. . .

[WannaBPowerful]

When drawing QV Enanth. do you use like a 19g drawing kneedle, or do you draw with the needle your also going to be injecting with?

Also, is there any procedure to drawing from a vial that i should know about? Iv only used amps.

 

[NapoleanComplex]

fill the syringe w/ air before you poke the vial. If your shooting 2 ccs, then fill w/ 2 ccs of air. Poke the vial push the air into the vial. Draw in the fluid.

You can use a different needle to draw, or the same needle that you plan to poke with.

 

[THE_BIG_FED]

after being stubborn for the longest time and drawing and poking with the same 25G....i've been using some 23G i had around, and they pull much faster....as well the injection goes better because the 25G is fresh and untouched. vials are different only in the fact you turn them upside down to draw, where amps you just tilt a little and draw straight up.

 

[SofaGeorge]

I bought 18 guage drawing needles... then switch to a 23 guage pin to shoot.

I never use a pin to shoot that has been pushed through a rubber stopper. Even that little contact dulls the point.

18 guage drawing pins are necessary if you are using high concentration formulas.

 

[psychedout]

18 guage drawing pins are necessary if you are using high concentration formulas.

Whats the reason for this.. out of curiousity..

 

[rooster1]

I don't like to draw bigger than an 23G

because it leaves a big hole in the rubber stopper and when you turn it upside down it leaks oil through the stopper.I draw w/a 23G and inject with the same dart or if doing the thighs I will switch to a 25G.Higher concentration oils are thicker and harder to draw and so a bigger pin is helpful.