Dieting BEFORE Cycle

[tzan]

I'm going to be running a spring/summer lean bulking cycle consisting of:
600mg primo wks 1-10
40mg var wks 6-13
MAYBE a low dose of test

I'm going to begin this dance in late May. Currently my bf is at 11%. I would like to get it down as low as I can before I start so I can up the cals and later when I start he cycle. My question is for all of those who like to CLEAN BULK, how low do you get your bf down to before you start your cycle? I don't want to get it down to the point where I'm losing a lot of strength.

 

[Makavelli]

I'm going to be running a spring/summer lean bulking cycle consisting of:
600mg primo wks 1-10
40mg var wks 6-13
MAYBE a low dose of test

I'm going to begin this dance in late May. Currently my bf is at 11%. I would like to get it down as low as I can before I start so I can up the cals and later when I start he cycle. My question is for all of those who like to CLEAN BULK, how low do you get your bf down to before you start your cycle? I don't want to get it down to the point where I'm losing a lot of strength.

I like to get as lean as possible. But 7-8% will suffice if you don't want to drop a lot of strength. When you bulk, I wouldn't let your body fat get above 12%. It's a bitch losing it again.

 

[gimp]

10% is fine for me...I don't put on fat that easily and if you eat clean you should put on minimal fat. consider a low dose of tren so you can balance out your cycle, it's more anabolic than androgenic. andro's help keep fat off

 

[tzan]

Yea, I figure if I could just get down a little more to 8-9% I'll be good to go. Realisticly I don't expect to gain 20lbs of lean mass off of this cycle. I would be pleased if I could keep my bf down in the single digits and gain anything over 10lbs.