Did I Screw up my Growth Hormone!!??

[gymrat surfer]

SO PUMPED! Got my Jinotropin today! So as soon as I am getting ready to mix my first 8IU jar, I have added 1ml of solution to it and for some reason, the water shot down quick where the growth bubbled. I know I was supposed to let it drip on the side of the vial and then slowly swirl it but for some reason when I put the needle in, the water by itself went so quick. (guess I will have to pull back on the plunger next time..

Did I screw up my GH? Should I throw it out or is it o.k. to still use?

Also, I added 1ML to the 8IU, for each 1IU, what would that measure 12.5 units on the slin pin? thanks!!

 

[Only1eagle]

If the bottle of GH is sealed properly then there is low pressure in the bottle. As soon as it finds something to fill that space it draws it right in. You can alwas add air first then the fluid or just hold the plunger when you insert the needle to allow it to flow slowly.

In regards to the GH. It is fine to shoot it. It may have degraded the potency a bit but there shoudl still be enough for the job at hand.

 

[gymrat surfer]

Thanks Eagle! I also figured it was still good to go too...

 

[ALIN]

SO PUMPED! Got my Jinotropin today! So as soon as I am getting ready to mix my first 8IU jar, I have added 1ml of solution to it and for some reason, the water shot down quick where the growth bubbled. I know I was supposed to let it drip on the side of the vial and then slowly swirl it but for some reason when I put the needle in, the water by itself went so quick. (guess I will have to pull back on the plunger next time..

Did I screw up my GH? Should I throw it out or is it o.k. to still use?

Also, I added 1ML to the 8IU, for each 1IU, what would that measure 12.5 units on the slin pin? thanks!!

Its fine,,next time just be a little more careful and let it slide down the side of the vial.

 

[gymrat surfer]

Thanks again! Do you use an slin pin or regular cc syrange to inject the 1ml solution? Wondering if using a slin pin would allow me to be more careful with adding water gently...

 

[jacshelb]

I use a slin pin. Sometimes I'll pull the plunger completely out and jab the vial to let it equalize pressure with air. Then, like everyone else said, just let it run down the side.

 

[gymrat surfer]

I use a slin pin. Sometimes I'll pull the plunger completely out and jab the vial to let it equalize pressure with air. Then, like everyone else said, just let it run down the side.

What do you mean by that?

 

[ghettostudmuffin]

He means basically pull the plunger of the slin syringe out and then jab the slin needle into the rubber stopper. Any pressurized air inside the vial will leak out through the needle.

 

[axe3]

here is what i do. get a slin pin pull plunger all the way back so its filled w/ air. Put into unreconstituted gh vial let it equalize then use same pin get backstat h2o and then put it into gh - that way i control how fast it goes in and it doesnt get vacuum sucked in

 

[gymrat surfer]

Not a bad idea. Maybe i'll just shoot 3ML of air into it first, then suck in 1ml of bac water but pull plunger back all way and then let drip down sides SLOWLY... Can't wait to reconstitute my next vial. This GH stuff is so much fun! Best part is I know I am committed for the long term and will not judge it until after 1 year straight.