cutting gear with Ethyl Oleate?

[jacob600rr]

can Ethyl Oleate be used to cut t.est, dec.a or t.ren? if so would you be able to use a smaller pin say 25 or 27??
thanks

 

[xrsist]

why do you wish to cut your gear mate?

 

[jumpmaster82]

you cutting it cuz its to thick? Hurt to pin it?

 

[jacob600rr]

just wanted to use smaller pins if possible

 

[hesnobradpitt]

just wanted to use smaller pins if possible

EO will make it thinner but it can disolve some rubber stoppers so be careful

Brad.

 

[nydj66]

EO is compatible with the oils used to solublize gear so yes you can cut with it.

But, cutting your gear will mean you have to inject higher volumes.

Have you tried heating your gear by holding the syringe under hot running water before injecting? That should allow you to use a smaller guage. I personally haven't had any luck going smaller than 25g.

 

[needtogetaas]

just wanted to use smaller pins if possible

Draw with one pin and inject with another. Every one should be doing this any way.

 

[b_light]

no shit bro pins are so cheap!

 

[jagerbombme]

i've injected up to 350mg/ml through a 25, but i draw with a 20