chemistry help Please ???

[blueeyeddevil]

Ok put together a batch of test prop last night using the syno kit . Everything went perfect . Test was a lil cloudy but as soon as I put some heat to it it turned clear and perfect . Filtered 45cc with a whatman and went to bed . Now this morning it had totally callapsed (ended up at 100mg/cc by the way) . I put some more heat to it and it cleared right up . Whats wrong ? Will I have to put heat to it each time I go to use it or is it just trashed ? The 45cc I didn't filter with the whatmans stills looks great by the way . I always get the best help from the guys on this board so thanks again ...

 

[blueeyeddevil]

Did I lose you guys or what ???

 

[Trendsetter21]

EF has a chemistry board that might get you a better answer then posting it on this board. I do not know the answer to your question but like I said the guys that frequent there might.

 

[needtogetarmy]

It crashed. Your potency may be more than 100mg/ml.

I would be very careful because it looks like (1) your measurements are off or (2) you don't have real prop. The critical component with any brew is BA. It protects you against the bacteria so as long as you have 2-5% you should be fine. (1% is the absolute minimum).

What you can do is take some oil or BB and add a bit to lower the consistency of the brew and see what happens. The only time I have had powders crash is when I go for too high a mixture.

Good luck.

 

[blueeyeddevil]

Ok you know your shit , that is exactly what I thought was happening . I new the prop would get unstable past 100mg and my scale kept underweighing the powder . Thanks a lot bro !