Can't Inject My Suspension!!!!

[StoneColdGold]

ok whats the deal. is there some kind of trick with injecting test suspension? I'm using a 23 gauge needle. I can pull it into the needle no problem. But trying to push it out is nearly impossible. What's going on????

 

[D-Pump357]

use the biggest guage you can handle. Test suspension is hard to get out.

 

[O'Stanozol]

try a 22 gauge,
and go slowly
and why on earth you went with susp?

 

[batgirl]

is test Enan same way or you can use a 25g?

 

[Citruscide]

I've shot just about everything I've done through a 25G. It just takes a freekin' long time sometimes. I LOVE those 25'ers... I don't know how I could ever go back to a lower guage anymore.

C

 

[dto]

i couldnt get Jurox suspension to pass through an 18g susta harpoon..what i did was mix it with something else...fina worked fine, also susta worked fine too.
so 1cc suspension and 1cc of susta and it will inject with a 23g no prob

 

[BigRugbyMan]

i can inject susp with a slin pin... You might be injecting close to a bone or a bump from previous injection... Happens to me sometimes, then i pull the dart out a bit and it works fine

 

[BigRugbyMan]

Re: !

Suspension is not worth the trouble -- throw it away and get somw eth, cyp, prop or sus250. Sorry for that news but it is certainly the worst test choice. Not my opinion -- a well documented fact.

may i ask why?

 

[SaltyOlPirate]

What is the consistency of Susp.? Is it like paste? You cannot get it through a 23 guage needle thats crazy.
Goodluck guys

 

[Slopain]

Suspension has its place, and is an awesome AAS. It is a pain in the ass and comes with its share of sides, but its a very powerfull test.

Sounds like you have un-micronized suspension, take a 22g needle and suck up an oil based AS (just enough to fill the needle only) and either keep it in there or spit it out of the dart then pull up the Test suspension you shouldnt have a problem. The oil based compound will lubricate the needle letting the unmicronized testosterone suspension pass through with ease. If you can get micronized do it, but if not this technique is workable.