a lump every single time I inject..advice?

[str8cubano]

I have two different Enths. One is suspended in ethyl oleate, the other in some sort of coconut oil? I have no clue, but it is thick as can be. Long story short, after 5 weeks of mixing the two into one syringe and injecting, there is not one time that I don't get a lump. I started getting them real bad after week 2. They are pretty bad. My ass has no more room for lumps. I have expereinced this before, but not like this. I am injecting a total of 1.5ccs twice a week. Should I divide that dose into to different injections in two different sites? I know this stuff is working, but fuck...not sure where to inject anymore. I am using a 22 gauge 1.5". The thick oil based enth will not travel through the 25 gauge. Maybe it's the way I inject, but I have done it many many many times before without this amount of brusing and lumps...I haven't had much luck with quad injections....any suggestions? Thanks

str8cubano

 

[HAYEZ]

could you cut the thicker oil with sterile oil to thin it up? wonder if it would mix ok?

 

[access]

Sounds like some sort of reaction your having to the gear so I think even if you added some other oil to it might not have much effect but you could try.

 

[littleb]

damn bro, only advice i have you may have tried already, I trust that you trust your gear, {i.e quality} besides cutting it, have you tried heating it b4 injection, injecting super slow, and massage area of injection for about 5 min. right after followed by hot shower....

 

[halfcenturian]

damn bro, only advice i have you may have tried already, I trust that you trust your gear, {i.e quality} besides cutting it, have you tried heating it b4 injection, injecting super slow, and massage area of injection for about 5 min. right after followed by hot shower....

+1 Shoot your Quads for a while... and massage into tissue. Obviously go deep. I shoot 200mg Test Cyp 2 times a week thru a 25g x 1" pin. Heat it up.

 

[the elite addict]

sounds like bad gear and or high BA content. Not much you can do.

 

[sugashane]

damn bro, only advice i have you may have tried already, I trust that you trust your gear, {i.e quality} besides cutting it, have you tried heating it b4 injection, injecting super slow, and massage area of injection for about 5 min. right after followed by hot shower....

Try these ideas, if they don't work you probably just have really low quality gear.

 

[ceo]

could be the EO. Some ppl have bad reactions to EO.

 

[str8cubano]

could be the EO. Some ppl have bad reactions to EO.

I have had that before and haven't reacted to it. I will try these ideas though...thanks

 

[str8cubano]

well its the kernal oil one. I injected both enths on two diff quads. Lump is only in the really thick one. Could this mean that it's not effective? Or it is, just simply I that I have to deal with this? I have been getting great results but I have also been using BOTH of them throughout the cycle...